DATASHEET
ISL91133
FN8680
Rev 1.00
Jul 12, 2018
High Efficiency 2.3A Boost Regulator with Input-to-Output Bypass
The ISL91133 is an integrated boost switching regulator for
Features
battery powered applications. The device provides a power
supply solution for products using a one cell Li-ion or
Li-polymer battery.
• Input voltage range: 2.35V to 5.4V
• Output current: up to 2.3A (V = 2.5V, V
= 3.3V)
IN OUT
The device is capable of delivering up to 2.3A output current
• Burst current up to 2.5A (V = 2.5V, V
= 3.3V,
IN OUT
from V = 2.5V and V
= 3.3V. The no load quiescent
t
< 600µs, T = 4.6ms)
IN OUT
ON
• High efficiency: up to 96%
current is only 108μA in Boost mode and 45μA in Forced
Bypass mode, which significantly reduces the standby
consumption.
• 108µA quiescent current minimizes standby consumption in
Boost mode, 45µA in Forced Bypass mode
The ISL91133 offers a Bypass mode operation where the
output is directly connected to the input through a 38mΩ
MOSFET to allow a significantly lower dropout voltage. The
Bypass mode can be entered by an external command, or by
auto bypass. The Forced Bypass mode allows the output
voltage to operate close to the input voltage and improves the
efficiency under these conditions.
• 2.5MHz switching frequency minimizes external component
size
• Forced Bypass or Auto Bypass modes with a 38mΩ switch
• PFM mode at light load currents
• Fully protected for overcurrent, over-temperature, and
undervoltage
The ISL91133 is designed to support 6 fixed output voltages
ranging from 3.15V to 5V. A voltage select pin is available for
each output variant to scale up the output voltage by a small
offset to compensate the load transient droop.
• Load disconnect when disabled
• Small 1.78mmx1.78mm WLCSP
Applications
The ISL91133 requires only an inductor and a few external
components to operate. The 2.5MHz switching frequency
further reduces the size of external components.
• Smartphones and tablet PCs
• Wireless communication devices
• 2G/3G/4G RF power amplifiers
• USB OTG power source
The ISL91133 is available in a 16 bump, 0.4mm pitch,
1.78mmx1.78mm WLCSP.
Related Literature
For a full list of related documents, visit our website
• ISL91133 product page
100
98
VIN
=
L1
4V
IN
96
94
92
90
88
86
84
82
80
78
76
74
72
70
2.35V TO 5.4V
V
OUT = 3.3V TO VIN
UP TO 2.3A
ISL91133IIMZ
0.47µH
LX
VOUT
3V
IN
C2
2x22µF
C1
2.7V
IN
22µF
VIN
EN
2.5V
IN
AUTO BYPASS
BYPS
VSEL
R1
FORCED BYPASS
RESET
VOUT HI
PG
VOUT LO
PGND GND
0.001
0.01
0.1
1
I
(A)
OUT
FIGURE 1. TYPICAL APPLICATION
FIGURE 2. EFFICIENCY vs LOAD CURRENT, V = 3.3V
OUT
FN8680 Rev 1.00
Jul 12, 2018
Page 1 of 14