DATASHEET
ISL9000A
FN6391
Rev 3.00
October 15, 2015
Dual LDO with Low Noise, Very High PSRR and Low IQ
ISL9000A is a high performance dual LDO capable of sourcing
300mA current from each output. It has a low standby current
and very high PSRR and is stable with output capacitance of
1µF to 10µF with ESR of up to 200m.
Features
• Integrates two 300mA high performance LDOs
• Excellent transient response to large current steps
• ±1.8% accuracy over all operating conditions
The device integrates an individual Power-On-Reset (POR)
function for each output. The POR delay for VO2 can be
externally programmed by connecting a timing capacitor to the
CPOR pin. The POR delay for VO1 is internally fixed at
approximately 2ms. A reference bypass pin is also provided for
connecting a noise filtering capacitor for low noise and high-
PSRR applications.
• Excellent load regulation: < 0.1% voltage change across full
range of load current
• Low output noise: typically 30µV
• Very high PSRR: 90dB @ 1kHz
@ 100µA (1.5V)
RMS
• Extremely low quiescent current: 42µA (both LDOs active)
• Wide input voltage capability: 2.3V to 6.5V
The quiescent current is typically only 42µA with both LDO’s
enabled and active. Separate enable pins control each
individual LDO output. When both enable pins are low, the
device is in shutdown, typically drawing less than 0.1µA.
• Low dropout voltage: typically 200mV @ 300mA
• Stable with 1µF to 10µF ceramic capacitors
• Separate enable and POR pins for each LDO
Several combinations of voltage outputs are standard. Output
voltage options for each LDO range from 1.5V to 3.3V. Other
output voltage options may be available upon request.
• Soft-start and staged turn-on to limit input current surge
during enable
• Current limit and overheat protection
• Tiny 10 Ld 3mmx3mm DFN package
• -40°C to +85°C operating temperature range
• Pb-free (RoHS compliant)
Applications
• PDAs, Cell Phones and Smart Phones
• Portable Instruments, MP3 Players
• Handheld Devices including Medical Handheld
ISL9000A
10
1
VIN (2.3 TO 6.5V)
VO1
VIN
VO1
VO2
ON
ON
9
2
EN1
VO2
ENABLE1
ENABLE2
VO2 OK
VO2 TOO LOW
OK
OFF
OFF
8
3
4
EN2
POR2
POR1
RESET2
(200ms DELAY,
C3 = 0.01µF)
7
6
CBYP
V
OUT1
5
CPOR
GND
RESET1
(2ms DELAY)
VO1 TOO LOW
C1
C2
C3
C4
C5
C1, C4, C5: 1µF X5R CERAMIC CAPACITOR
C2: 0.1µF X7R CERAMIC CAPACITOR
C3: 0.01µF X7R CERAMIC CAPACITOR
FIGURE 1. TYPICAL APPLICATION
FN6391 Rev 3.00
October 15, 2015
Page 1 of 14