DATASHEET
ISL75051ASEH, ISL73051ASEH
3A, Radiation Hardened, Positive, Ultra-Low Dropout Regulator
FN8964
Rev.3.00
May 16, 2019
The ISL75051ASEH and ISL73051ASEH are radiation
hardened low-voltage, high-current, single-output LDOs
Features
• DLA SMD 5962-11212
specified for up to 3.0A of continuous output current.
These devices operate across an input voltage range of
2.2V to 6.0V and can provide output voltages of 0.8V to
5.0V adjustable, based on the resistor divider setting.
Dropout voltages as low as 65mV can be achieved using
the device.
• Output current up to 3.0A at T = +150°C
J
• Output accuracy ±1.5% over MIL temperature range
• Ultra low dropout:
• 65mV (typical) dropout at 1.0A
The OCP pin allows the short-circuit output current limit
threshold to be programmed by a resistor from the OCP
pin to GND. The OCP setting range is 0.5A minimum to
8.5A maximum. The resistor sets the constant current
threshold for the output under fault conditions. The
thermal shutdown disables the output if the device
temperature exceeds the specified value. It subsequently
enters an ON/OFF cycle until the fault is removed. The
ENABLE feature allows the part to be placed into a low
current shutdown mode that typically draws about 10µA.
• 225mV (typical) dropout at 3.0A
• SET mitigation with no added filtering/diodes
• Input supply range: 2.2V to 6.0V
• Fast load transient response
• Shutdown current of 10µA (typical)
• Output adjustable using external resistors
• PSRR 66dB (typical) at 1kHz
• Enable and PGood features
These devices are optimized for fast transient response and
Single Event Effects (SEE). This reduces the magnitude of
Single Event Transients (SET) seen on the output.
Additional protection diodes and filters are not needed.
These devices are stable with tantalum capacitors as low as
47µF and provide excellent regulation all the way from no
load to full load. Programmable soft-start allows the user
to program the inrush current by using the decoupling
capacitor value on the BYP pin.
• Programmable soft-start/inrush current limiting
• Over-temp shutdown and programmable OCP limits
• Stable with 47µF min tantalum capacitor
• Radiation hardness (ISL75051ASEH only)
• High dose rate (50-300rad(Si)/s): 100krad(Si)
• Low dose rate (≤0.01rad(Si)/s): 50krad(Si)
• Radiation hardness (ISL73051ASEH only)
• Low dose rate (≤0.01rad(Si)/s): 50krad(Si)
Applications
• LDO regulator for space applications
• DSP, FPGA, and µP core power supplies
• Post-regulation of switched mode power supplies
• Down-hole drilling
Related Literature
• For a full list of related documents, visit our website:
• ISL75051ASEH, ISL73051ASEH device pages
0.30
EN
+150°C
EN
BYP
ADJ
ROCP
0.25
0.1µF
OCP
+125°C
ISL75051ASEH
VIN
VOUT
220µF
0.20
VIN
PG
VOUT
GND
R
1
0.15
0.1µF
0.1µF
220µF
+25°C
2.67k
VIN
0.10
0.05
0.00
4.7nF
100pF
R
PG
2
0.00
0.50
1.00
1.50
2.00
(A)
2.50
3.00
3.50
I
OUT
Figure 2. Dropout vs I
Figure 1. Typical Application
OUT
FN8964 Rev.3.00
May 16, 2019
Page 1 of 22