DATASHEET
ISL72028SEH
FN8764
Rev 3.00
August 16, 2016
3.3V Radiation Tolerant CAN Transceiver, with Low Power Shutdown, Split
Termination Output
The Intersil ISL72028SEH is a radiation tolerant 3.3V CAN
Features
transceiver that is compatible with the ISO11898-2 standard for
• Electrically screened to SMD 5962-15228
applications calling for Controller Area Network (CAN) serial
communication in satellites and aerospace communications, and
telemetry data processing in harsh industrial environments.
• ESD protection on all pins. . . . . . . . . . . . . . . . . . . . . .4kV HBM
• Compatible with ISO11898-2
The transceiver can transmit and receive at bus speeds up to
5Mbps. It can drive a 40m cable at 1Mbps per the ISO11898-2
specification. The device is designed to operate over a common-
mode range of -7V to +12V with a maximum of 120 nodes. The
device has three discrete selectable driver rise/fall time options, a
low power shutdown mode and a split termination output.
• Operating supply range . . . . . . . . . . . . . . . . . . . . . 3.0V to 3.6V
• Bus pin fault protection to ±20V
• Undervoltage lockout
• Cold spare: powered down devices/nodes will not affect
active devices operating in parallel
Receiver (Rx) inputs feature a “full fail-safe” design, which
ensures a logic high Rx output if the Rx inputs are floating,
shorted, or terminated but undriven.
• Three selectable driver rise and fall times
• Glitch free bus I/O during power-up and power-down
• Full fail-safe (open, short, terminated/undriven) receiver
• Hi Z input allows for 120 nodes on the bus
The ISL72028SEH is available in an 8 Ld hermetic ceramic
flatpack and die form that operate across the temperature range
of -55°C to +125°C. The logic inputs are tolerant with 5V
systems.
• High data rates. . . . . . . . . . . . . . . . . . . . . . . . . . . . up to 5Mbps
• Quiescent supply current . . . . . . . . . . . . . . . . . . . . 7mA (max)
Other CAN transceivers available are the ISL72026SEH and
ISL72027SEH. For a list of differences see Table 1 on page 2.
• Low power shutdown mode . . . . . . . . . . . . . . . . . .50µA (max)
• -7V to +12V common-mode input voltage range
• 5V tolerant logic inputs
• Thermal shutdown
Related Literature
• UG051, “ISL7202xSEHEVAL1Z Evaluation Board User Guide”
• Acceptance tested to 75krad(Si) (LDR) wafer-by-wafer
• Radiation tolerance
• TR018, “Single Event Effects (SEE) Testing of the ISL72027SEH
CAN Transceiver”
2
- SEL/B immune to LET 60MeV•cm /mg
• TR022, “Total Dose Testing of the ISL72026SEH, ISL72027SEH
and ISL72028SEH CAN Transceivers”
- Low dose rate (0.01rad(Si)/s) . . . . . . . . . . . . . . .75krad(Si)
Applications
• Satellites and aerospace communications
• Telemetry data processing
• High-end industrial environments
• Harsh environments
4
D
RS
Tx DATA IN
VCC
1
2
3
4
8
7
6
5
D
0
CANH
CANH
CANL
GND
4
ISL72028SEH
CANL
R
0
VCC
0.1µF
VREF
R
3
RS = GND, R
= 60Ω
DIFF
2
1
0
CANH - CANL
Rx DATA OUT
TIME (1µs/DIV)
FIGURE 1. TYPICAL APPLICATION
FIGURE 2. FAST DRIVER AND RECEIVER WAVEFORMS
FN8764 Rev 3.00
August 16, 2016
Page 1 of 18