DATASHEET
ISL72028BSEH
3.3V Radiation Tolerant CAN Transceiver, with Low-Power Shutdown, Split
Termination Output
FN8902
Rev 0.00
November 30, 2016
The ISL72028BSEH is a radiation tolerant 3.3V CAN transceiver
Features
that is compatible with the ISO11898-2 standard for applications
• Electrically screened to SMD 5962-15228
calling for Controller Area Network (CAN) serial communication in
satellites and aerospace communications, and telemetry data
processing in harsh industrial environments.
• ESD protection on all pins. . . . . . . . . . . . . . . . . . . . . .4kV HBM
• Compatible with ISO11898-2
The transceiver can transmit and receive at bus speeds up to
5Mbps. It can drive a 40m cable at 1Mbps per the ISO11898-2
specification. It was designed to operate over a common-mode
range of -7V to +12V with a maximum of 120 nodes. The device
has three discrete selectable driver rise/fall time options, a
Low-Power Shutdown mode and a split termination output.
• Operating supply range . . . . . . . . . . . . . . . . . . . . . 3.0V to 3.6V
• Bus pin fault protection to ±20V
• Undervoltage lockout
• Cold spare: powered-down devices/nodes will not affect
active devices operating in parallel
Receiver (Rx) inputs feature a “full fail-safe” design, which
ensures a logic high Rx output if the Rx inputs are floating,
shorted, or terminated but undriven.
• Three selectable driver rise and fall times
• Glitch free bus I/O during power-up and power-down
• Full fail-safe (open, short, terminated/undriven) receiver
• Hi-Z input allows for 120 nodes on the bus
The ISL72028BSEH is available in an 8 Ld hermetic ceramic
flatpack and die form that operate across the temperature range
of -55°C to +125°C. The logic inputs are tolerant with 5V
systems.
• High data rates. . . . . . . . . . . . . . . . . . . . . . . . . . . . up to 5Mbps
• Quiescent supply current . . . . . . . . . . . . . . . 7mA (maximum)
• Low-Power Shutdown mode . . . . . . . . . . . . 50µA (maximum)
• -7V to +12V common-mode input voltage range
• 5V tolerant logic inputs
Other CAN transceivers available are the ISL72026BSEH and
ISL72027BSEH. For a list of differences see Table 1 on page 2.
Related Literature
• For a full list of related documents, visit our website
- ISL72028BSEH product page
• Thermal shutdown
• Acceptance tested to 75krad(Si) (LDR) wafer-by-wafer
• Radiation tolerance
2
Applications
- SEL/B immune to LET . . . . . . . . . . . . 86.4MeV•cm /mg
TH
• Satellites and aerospace communications
• Telemetry data processing
• High-end industrial environments
• Harsh environments
- Low dose rate (0.01rad(Si)/s) . . . . . . . . . . . . . . .75krad(Si)
- High dose rate (50-300rad(Si)/s). . . . . . . . . . . 100krad(Si)
4
ISL72028BSEH
D
0
4
D
RS
CANH
CANL
VREF
Tx DATA IN
VCC
1
2
3
4
8
7
6
5
R
0
CANH
CANL
GND
VCC
R
3
0.1µF
RS = GND, R
DIFF
= 60Ω
2
1
0
CANH - CANL
Rx DATA OUT
TIME (1µs/DIV)
FIGURE 1. TYPICAL APPLICATION
FIGURE 2. FAST DRIVER AND RECEIVER WAVEFORMS
FN8902 Rev 0.00
November 30, 2016
Page 1 of 20