DATASHEET
ISL70002SEH, ISL73002SEH
Radiation Hardened and SEE Hardened 22A Synchronous Buck Regulators with
Current Sharing
FN8264
Rev.12.01
Mar 31, 2022
The ISL70002SEH and ISL73002SEH (ISL7x002SEH) are
Features
radiation hardened and SEE hardened high-efficiency
• DLA SMD 5962-12202
• Maximum output current (“Single Phase”):
- 22A with external Schottky (T ≤125°C, PVIN ≤5.5V)
monolithic, synchronous buck regulators with integrated
MOSFETs. This single chip power solution operates over an
input voltage range of 3V to 5.5V and provides a tightly
regulated output voltage that is externally adjustable from
0.8V to ~85% of the input voltage. Output load current
capability is primarily determined by PVIN voltage with up to
J
- 18A (T ≤125°C, PVIN ≤5.5V)
J
- 14A (T ≤125°C, PVIN ≤6.2V)
J
- 12A (T ≤150°C, PVIN ≤6.2V)
22A for a single IC at PVIN ≤ 5.5V for T ≤ +125°C. Two
J
J
ISL7x002SEH devices, configured to current share, can
• Maximum output current (“Dual Phase”)
- 38A (27% worst case current sharing)
• 1MHz or 500kHz switching frequency
provide up to 38A of total output current at PVIN ≤ 5.5V for T
≤ +125°C assuming ±27% worst-case current share
accuracy.
J
• 3V to 6.2V supply voltage range
The devices use peak current-mode control with integrated
error amp compensation and pin-selectable slope
• ±1% reference voltage (line, load, temperature, and rad)
compensation. Switching frequency is also pin selectable to
either 1MHz or 500kHz. Two devices can be synchronized
180° out-of-phase to reduce input RMS ripple current.
• Redundancy/junction isolation: exceptional SET
performance
• Excellent transient response
High integration makes them an ideal choice to power small
form factor applications. Two devices can be synchronized to
provide a complete power solution for large scale digital ICs,
like Field Programmable Gate Arrays (FPGAs) that require
separate core and I/O voltages.
• High efficiency >90%
• Two ISL7x002SEH synchronization, inverted-phase
• Comparator input for enable and power-good
• Input undervoltage, output undervoltage, and adjustable
output overcurrent protection
The ISL7x002SEH is available in a thermally enhanced heat
spreader package (R64.C)
• QML qualified per MIL-PRF-38535
• Full military temperature range operation (-55°C to
+125°C)
Applications
• FPGA, CPLD, DSP, CPU core, and I/O voltages
• Radiation environment - ISL70002SEH
- HDR (50-300rad(Si)/s): 100krad(Si)
- LDR (0.01rad(Si)/s): 50krad(Si)
• Low-voltage, high-density distributed power systems
• Radiation environment - ISL73002SEH
- LDR (0.01rad(Si)/s): 50krad(Si).
• SEE hardness (See the SEE Test report for details)
2
2
2
- SEL and SEB LET . . . . . . . . . . . . . . . . 86.4MeV/mg/cm
TH
- SEFI LET . . . . . . . . . . . . . . . . . . . . . . . . . . 43MeV/mg/cm
TH
- SET LET . . . . . . . . . . . . . . . . . . . . . . . . 86.4MeV/mg/cm
TH
100
95
90
85
80
75
70
65
25
CH1 MASTER LX + 20V
20
15
10
5
CH2 SLAVE LX + 15V
CH3 VOUT x 10
0.95VOUT
1.5VOUT
2.5VOUT
1.2VOUT
1.8VOUT
3.3VOUT
60
55
50
CH4 SYNC
0
-6
0
2
4
6
8
10 12 14 16 18 20 22
-4
-2
0
2
4
6
8
10
12
14
Load Current (A)
2
FIGURE 2. 2-PHASE SET PERFORMANCE AT 86.4MeV/mg/cm
FIGURE 1. EFFICIENCY 5V INPUT, 500kHz, T
= +25°C
case
FN8264 Rev.12.01
Mar 31, 2022
Page 1 of 27
© 2012-2022 Renesas Electronics