ISL6536
®
Data Sheet
December 28, 2004
FN9114.2
Four Channel Supervisory IC
Features
The ISL6536 is a four channel supervisory IC designed to
monitor voltages >, = 0.7V. This IC bias range is from 2.7V to
4V but can supervise any positive voltage using an external
resistor divider to translate to a lower voltage for comparison
to the internal 0.63V reference.
• Adjustable undervoltage lockout for each supply
• Active high PGOOD Output
• Guaranteed PGOOD Valid to Falling VDD < 1V
• VMON Glitch Immunity
Once properly biased and enabled when all four voltage
monitor (VMON) inputs are satisfied the PGOOD output will
be immediately released to go high to signal that voltage is
valid on all four rails. Subsequently when the monitored
voltage on any rail drops below its user defined threshold
point, the PGOOD output is pulled low. Each rail’s VMON
point is independently adjustable with a resistor divider. The
PGOOD output is guaranteed to be valid with IC bias lower
than 1V. The VMON inputs will ignore 30µs transients on the
monitored supplies. The PGOOD output is an open-drain to
allow ORing of multiple signals and interfacing to a range of
logic levels. The ENABLE input provides for a reset of the
PGOOD output when it is pulled down below 0.5V. With an
internal 10uA pull-up to VDD it can be signalled with
• Pb-Free Available (RoHS Compliant)
Applications
• Graphics Cards
• Multi voltage DSPs and Processors
• µP Voltage Monitoring
• Embedded Control Systems
• Intelligent Instruments
• Medical Equipment
• Network Routers
• Portable Battery-Powered Equipment
• Set-Top Boxes
common logic or pulled to ground with a push button switch.
Typical Application Schematic
• Telecommunications Systems
Ordering Information
ISL6536
PART
NUMBER
TEMP. RANGE
(°C)
PKG.
DWG. #
PACKAGE
1
2
3
4
VDD
PGD
EN
VMON1
VMON2
VMON3
VMON4
8
7
6
5
ISL6536IB
-40 to +85
-40 to +85
8 LD SOIC
M8.15
M8.15
*OPT
ISL6536IBZ
(See Note)
8 LD SOIC
(Pb-free)
ISL6536IB-T
8 LD SOIC Tape and Reel
8 LD SOIC (Pb-free)
GND
ISL6536IBZ-T
(See Note)
NOTE: Intersil Pb-free products employ special Pb-free material sets;
molding compounds/die attach materials and 100% matte tin plate
termination finish, which are RoHS compliant and compatible with
both SnPb and Pb-free soldering operations. Intersil Pb-free products
are MSL classified at Pb-free peak reflow temperatures that meet or
exceed the Pb-free requirements of IPC/JEDEC J STD-020.
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2004. All Rights Reserved.
1
All other trademarks mentioned are the property of their respective owners.