5秒后页面跳转
捷配首页

Datasheet > 存储 > SRAM> IS61QDB24M18-300M3
IS61QDB24M18-300M3 PDF预览

IS61QDB24M18-300M3

更新时间： 2024-11-18 05:39:35
品牌 Logo 应用领域
美国芯成 - ISSI 存储内存集成电路静态存储器双倍数据速率时钟
页数 文件大小 规格书
27页 633K
描述
72 Mb (2M x 36 & 4M x 18) QUAD (Burst of 2) Synchronous SRAMs

阅读下载

中文翻译

获取价格

IS61QDB24M18-300M3 技术参数

是否无铅： 含铅是否Rohs认证： 不符合
生命周期：Obsolete零件包装代码：BGA
包装说明：15 X 17 MM, 1 MM PITCH, LFBGA-165针数：165
Reach Compliance Code：compliantECCN代码：3A991.B.2.A
HTS代码：8542.32.00.41风险等级：5.17
Is Samacsys：N最长访问时间：0.45 ns
其他特性：PIPELINED ARCHITECTURE最大时钟频率 (fCLK)：300 MHz
I/O 类型：SEPARATEJESD-30 代码：R-PBGA-B165
JESD-609代码：e0长度：17 mm
内存密度：75497472 bit内存集成电路类型：DDR SRAM
内存宽度：18功能数量：1
端子数量：165字数：4194304 words
字数代码：4000000工作模式：SYNCHRONOUS
最高工作温度：70 °C最低工作温度：
组织：4MX18输出特性：3-STATE
封装主体材料：PLASTIC/EPOXY封装代码：LBGA
封装等效代码：BGA165,11X15,40封装形状：RECTANGULAR
封装形式：GRID ARRAY, LOW PROFILE并行/串行：PARALLEL
峰值回流温度（摄氏度）：NOT SPECIFIED电源：1.5/1.8,1.8 V
认证状态：Not Qualified座面最大高度：1.4 mm
最小待机电流：1.7 V子类别：SRAMs
最大压摆率：0.8 mA最大供电电压 (Vsup)：1.89 V
最小供电电压 (Vsup)：1.71 V标称供电电压 (Vsup)：1.8 V
表面贴装：YES技术：CMOS
温度等级：COMMERCIAL端子面层：Tin/Lead (Sn/Pb)
端子形式：BALL端子节距：1 mm
端子位置：BOTTOM处于峰值回流温度下的最长时间：NOT SPECIFIED
宽度：15 mmBase Number Matches：1

IS61QDB24M18-300M3 数据手册

 浏览型号IS61QDB24M18-300M3的Datasheet PDF文件第2页浏览型号IS61QDB24M18-300M3的Datasheet PDF文件第3页浏览型号IS61QDB24M18-300M3的Datasheet PDF文件第4页浏览型号IS61QDB24M18-300M3的Datasheet PDF文件第5页浏览型号IS61QDB24M18-300M3的Datasheet PDF文件第6页浏览型号IS61QDB24M18-300M3的Datasheet PDF文件第7页 
.
72 Mb (2M x 36 & 4M x 18)  
QUAD (Burst of 2) Synchronous SRAMs  
May 2009  
• Two echo clocks (CQ and CQ) that are delivered  
simultaneously with data.  
Features  
• 2M x 36 or 4M x 18.  
• +1.8V core power supply and 1.5, 1.8V VDDQ  
used with 0.75, 0.9V VREF  
,
• On-chip delay-locked loop (DLL) for wide data  
valid window.  
.
• HSTL input and output levels.  
• Separate read and write ports with concurrent  
read and write operations.  
• Registered addresses, write and read controls,  
byte writes, data in, and data outputs.  
• Synchronous pipeline read with early write oper-  
ation.  
• Full data coherency.  
• Boundary scan using limited set of JTAG 1149.1  
functions.  
• Double data rate (DDR) interface for read and  
write input ports.  
• Byte write capability.  
• Fixed 2-bit burst for read and write operations.  
• Clock stop support.  
• Fine ball grid array (FBGA) package  
- 15mm x 17mm body size  
- 1mm pitch  
• Two input clocks (K and K) for address and con-  
trol registering at rising edges only.  
- 165-ball (11 x 15) array  
• Two input clocks (C and C) for data output con-  
trol.  
• Programmable impedance output drivers via 5x  
user-supplied precision resistor.  
Description  
The 72Mb IS61QDB22M36 and  
• Write address  
IS61QDB24M18 are synchronous, high-perfor-  
mance CMOS static random access memory  
(SRAM) devices. These SRAMs have separate I/Os,  
eliminating the need for high-speed bus turnaround.  
The rising edge of K clock initiates the read/write  
operation, and all internal operations are self-timed.  
Refer to the Timing Reference Diagram for Truth  
Table on page 8 for a description of the basic opera-  
tions of these SRAMs.  
• Byte writes  
• Data-in for second burst addresses  
Byte writes can change with the corresponding data-  
in to enable or disable writes on a per-byte basis. An  
internal write buffer enables the data-ins to be regis-  
tered half a cycle earlier than the write address. The  
first data-in burst is clocked at the same time as the  
write command signal, and the second burst is timed  
to the following rising edge of the K clock.  
The input address bus operates at double data rate.  
The following are registered internally on the rising  
edge of the K clock:  
During the burst read operation, the data-outs from  
the first burst are updated from output registers off  
the second rising edge of the C clock (1.5 cycles  
later). The data-outs from the second burst are  
updated with the third rising edge of the C clock. The  
K and K clocks are used to time the data-outs when-  
ever the C and C clocks are tied high.  
• Read address  
• Read enable  
• Write enable  
• Byte writes  
• Data-in for early writes  
The device is operated with a single +1.8V power  
supply and is compatible with HSTL I/O interfaces.  
The following are registered on the rising edge of  
the K clock:  
Integrated Silicon Solution, Inc.  
1
Rev. A  
05/14/09  
1234567...27

中文翻译

下载PDF

与IS61QDB24M18-300M3相关器件

型号 品牌 获取价格 描述 数据表
IS61QDB24M18-300M3L ISSI

获取价格

 		72 Mb (2M x 36 & 4M x 18) QUAD (Burst of 2) Synchronous SRAMs
IS61QDB24M18A ISSI

获取价格

 		2Mx36 and 4Mx18 configuration available
IS61QDB24M18A-250B4LI ISSI

获取价格

 		QDR SRAM, 4MX18, 0.45ns, CMOS, PBGA165, 13 X 15 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61QDB24M18A-300B4LI ISSI

获取价格

 		QDR SRAM, 4MX18, 0.45ns, CMOS, PBGA165, 13 X 15 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61QDB24M18A-300M3L ISSI

获取价格

 		QDR SRAM, 4MX18, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61QDB251236A ISSI

获取价格

 		512Kx36 and 1Mx18 configuration available
IS61QDB251236A-250M3L ISSI

获取价格

 		IC SRAM 18M PARALLEL 165LFBGA
IS61QDB251236A-300M3L ISSI

获取价格

 		QDR SRAM, 512KX36, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165
IS61QDB41M18A ISSI

获取价格

 		512Kx36 and 1Mx18 configuration available
IS61QDB41M18A-250M3L ISSI

获取价格

 		QDR SRAM, 1MX18, 0.45ns, CMOS, PBGA165, 15 X 17 MM, 1.40 MM HEIGHT, LEAD FREE, LFBGA-165

与IS61QDB24M18-300M3相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证