IS61LV6432
IS61LV6432
64K x 32 SYNCHRONOUS
PIPELINE STATIC RAM
FEATURES
DESCRIPTION
The ICSI IS61LV6432 is a high-speed, low-power synchro-
nous static RAM designed to provide a burstable, high-perfor-
mance, secondary cache for the Pentium™, 680X0™, and
PowerPC™ microprocessors. It is organized as 65,536 words
by 32 bits, fabricated with ICSI's advanced CMOS technology.
The device integrates a 2-bit burst counter, high-speed SRAM
core, and high-drive capability outputs into a single monolithic
circuit. All synchronous inputs pass through registers con-
trolled by a positive-edge-triggered single clock input.
• Internal self-timed write cycle
• Individual Byte Write Control and Global Write
• Clock controlled, registered address, data and
control
• Pentium™ or linear burst sequence control
using MODE input
• Three chip enables for simple depth expansion
and address pipelining
• Common data inputs and data outputs
• Power-down control by ZZ input
• JEDEC 100-Pin LQFP and PQFP package
• 3.3V VCC and 2.5V VCCQ for 2.5 I/O's
• Two Clock enables and one Clock disable to
eliminate multiple bank bus contention.
• Control pins mode upon power-up:
– MODE in interleave burst mode
– ZZ in normal operation mode
These control pins can be connected to GNDQ
or VCCQ to alter their power-up state
• Industrial temperature available
Write cycles are internally self-timed and are initiated by the
rising edge of the clock input. Write cycles can be from one to
four bytes wide as controlled by the write control inputs.
Separate byte enables allow individual bytes to be written.
BW1 controls DQ1-DQ8, BW2 controls DQ9-DQ16, BW3
controls DQ17-DQ24, BW4 controls DQ25-DQ32, conditioned
by BWE being LOW. A LOW on GW input would cause all bytes
to be written.
Bursts can be initiated with either ADSP (Address Status
Processor) or ADSC (Address Status Cache Controller) input
pins. Subsequent burst addresses can be generated internally
by the IS61LV6432 and controlled by the ADV (burst address
advance) input pin.
Asynchronous signals include output enable (OE), sleep mode
input (ZZ), clock (CLK) and burst mode input (MODE). A HIGH
input on the ZZ pin puts the SRAM in the power-down state.
When ZZ is pulled LOW (or no connect), the SRAM normally
operates after three cycles of the wake-up period. A LOW
input, i.e., GNDQ, on MODE pin selects LINEAR Burst. A VCCQ
(or no connect) on MODE pin selects INTERLEAVED Burst.
FAST ACCESS TIME
Symbol
tKQ
Parameter
CLK Access Time
-166
5
-133
5
-117
5
-5
5
-6
6
-7
7
-8
8
Unit
ns
tKC
Cycle Time
6
7.5
133
8.5
117
10
100
12
83
13
75
15
66
ns
—
Frequency
166
MHz
ICSI reserves the right to make changes to its products at any time without notice in order to improve design and supply the best possible product. We assume no responsibility for any errors
which may appear in this publication. © Copyright 2000, Integrated Circuit Solution Inc.
Integrated Circuit Solution Inc.
1
SSR005-0B