®
IS61VPD25636A IS61LPD25636A
IS61VPD51218A IS61LPD51218A
ISSI
256K x 36, 512K x 18
9 Mb SYNCHRONOUS PIPELINED,
DOUBLE CYCLE DESELECT STATIC RAM
MAY 2005
DESCRIPTION
FEATURES
The ISSIIS61LPD/VPD25636AandIS61LPD/VPD51218A
are high-speed, low-power synchronous static RAMs de-
signed to provide burstable, high-performance memory for
communicationandnetworkingapplications.TheIS61LPD/
VPD25636Aisorganizedas262,144wordsby36bits,and
the IS61LPD/VPD51218A is organized as 524,288 words
by18bits.FabricatedwithISSI'sadvancedCMOStechnol-
ogy,thedeviceintegratesa2-bitburstcounter,high-speed
SRAM core, and high-drive capability outputs into a single
monolithic circuit. All synchronous inputs pass through
registers controlled by a positive-edge-triggered single
clock input.
• Internal self-timed write cycle
• Individual Byte Write Control and Global Write
• Clock controlled, registered address, data and
control
• Burst sequence control using MODE input
• Three chip enable option for simple depth
expansion and address pipelining
• Common data inputs and data outputs
• Auto Power-down during deselect
• Double cycle deselect
Writecyclesareinternallyself-timedandareinitiatedbythe
risingedgeoftheclockinput.Writecyclescanbeonetofour
bytes wide as controlled by the write control inputs.
• Snooze MODE for reduced-power standby
• JTAG Boundary Scan for PBGA package
• Power Supply
Separate byte enables allow individual bytes to be written.
The byte write operation is performed by using the byte
write enable (BWE) input combined with one or more
individual byte write signals (BWx). In addition, Global
Write (GW) is available for writing all bytes at one time,
regardless of the byte write controls.
LPD: VDD 3.3V + 5%, VDDQ 3.3V/2.5V + 5%
VPD: VDD 2.5V + 5%, VDDQ 2.5V + 5%
Bursts can be initiated with either ADSP (Address Status
Processor) or ADSC (Address Status Cache Controller)
input pins. Subsequent burst addresses can be generated
internally and controlled by the ADV (burst address
advance) input pin.
• JEDEC 100-Pin TQFP,
119-pin PBGA and 165-pin PBGA package
The mode pin is used to select the burst sequence order,
Linear burst is achieved when this pin is tied LOW.
Interleave burst is achieved when this pin is tied HIGH or
left floating.
FAST ACCESS TIME
Symbol
tKQ
Parameter
250
2.6
4
200
3.1
5
Units
ns
Clock Access Time
Cycle Time
tKC
ns
Frequency
250
200
MHz
Copyright © 2005 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time without notice. ISSI assumes no liability
arisingoutoftheapplicationoruseofanyinformation, productsorservicesdescribedherein. Customersareadvisedtoobtainthelatestversionofthisdevicespecificationbeforerelyingonany
publishedinformationandbeforeplacingordersforproducts.
Integrated Silicon Solution, Inc. — 1-800-379-4774
Rev. A
1
05/09/05