®
IS25C32A
IS25C64A
ISSI
32K-BIT/64K-BIT SPI SERIAL
ELECTRICALLY ERASABLE PROM
PreliminaryInformation
March2006
FEATURES
DESCRIPTION
TheIS25C32AandIS25C64Aareelectricallyerasable
PROM devices that use the Serial Peripheral Interface
(SPI) for communications. The IS25C32A is 32Kbit
(4096 x 8) and the IS25C64A is 64Kbit (8192 x 8). The
IS25C32A/64A EEPROMs are offered in a wide
• SerialPeripheralInterface(SPI)Compatible
— Supports SPI Modes 0 (0,0) and 3 (1,1)
• Wide-voltageOperation
— Vcc = 1.8V to 5.5V
• LowpowerCMOS
operating voltage range of 1.8V to 5.5V to be compatible
with most application voltages. ISSI designed the
IS25C32A/64A to be an efficient SPI EEPROM solution.
The devices are packaged in 8-pin PDIP, 8-pin SOIC,
and 8-pin TSSOP.
— Active current less than 3.0 mA (2.5V)
— Standby current less than 2.0 µA (2.5V)
• Block Write Protection
— Protect 1/4, 1/2, or Entire Array
• 32 byte page write mode
— Partial page writes allowed
• 10 MHz Clock Rate (5V)
• Self timed write cycles (5 ms Typical)
• High-reliability
— Endurance: 1 million cycles per byte
— Data retention: 100 years
• IndustrialandAutomotivetemperatureranges
• 8-pin PDIP, 8-pin SOIC, and 8-pin TSSOP Packages
available
ThefunctionalfeaturesoftheIS25C32A/64Aallowthem
to be among the most advanced serial non-volatile
memories available. Each device has a Chip-Select
(CS) pin, and a 3-wire interface of Serial Data In (SI),
Serial Data Out (SO), and Serial Clock (SCK). While
the3-wireinterfaceoftheIS25C32A/64Aprovidesfor
high-speed access, a HOLD pin allows the memories to
ignore the interface in a suspended state; later the
HOLDpinre-activatescommunicationwithoutre-
initializing the serial sequence. A Status Register
facilitates a flexible write protection mechanism, and a
• Lead-freeavailable
device-readybit(RDY).
Copyright © 2006 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time
without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to
obtain the latest version of this device specification before relying on any published information and before placing orders for products.
Integrated Silicon Solution, Inc. — 1-800-379-4774
1
Preliminary Information Rev. 00E
02/07/06