Datasheet
IS-1715ARH, IS-1715AEH
Radiation Hardened Complementary Switch FET Drivers
The radiation hardened IS-1715ARH and
Features
IS-1715AEH are high speed, high current,
complementary power FET drivers designed for use
in synchronous rectification circuits. Soft switching
transitions for the two output waveforms can be
managed by setting the independently programmable
delays. Alternatively, the delay pins can be configured
for zero-voltage sensing to allow for precise switching
control.
• Electrically screened to SMD #5962-00521
• QML qualified per MIL-PRF-38535 requirements
• Radiation environment
5
○ Gamma dose 3x10 rad(Si)
○ Latch-up immune
• PWR output current (source and sink): 3A (peak)
• AUX output current (source and sink): 3A (peak)
• Low operating supply current: 6mA (max)
• Wide programmable delay range: 100ns to 600ns
• Configurable for zero-voltage switching
• Switching frequency to 1MHz
The IS-1715ARH and IS-1715AEH have a single
input, which is PWM and TTL compatible, and can run
at frequencies up to 1MHz. The AUX output switches
immediately at the rising edge of the INPUT, but waits
for the T2 delay before responding to the falling edge.
A logic low on the enable pin (ENBL) places both
outputs into an active-low mode, and an Undervoltage
Lockout (UVLO) function is set at 9V (maximum).
• Both outputs active-low in Sleep mode
• 9V (maximum) UVLO
These devices are constructed with the dielectrically
isolated Rad Hard Silicon Gate (RSG) process and
are immune to Single Event Latch-Up (SEL). They
have been specifically designed to provide highly
reliable performance in harsh radiation environments.
Related Literature
For a full list of related documents, visit our website:
• IS-1715ARH, IS-1715AEH device pages
Applications
• Synchronous rectification in power supplies
VCC
600
T1
T1
T1
-55 °C
VCC = 10V
125 °C 25 °C
500
400
IS-1715
INPUT
VCC
VCC
PWM
PWM
Controller
T1
PWR
300
200
100
0
T2
AUX
GND
GND
ENBL
-55 °C
T2
25 °C
T2
125 °C
T2
R 1
R 2
T
T
0
10
20
30
40
50
60
70
80
90 100
GND
R
(kΩ)
T
Figure 2. T1 Delay, T2 Delay vs RT vs Temperature
Figure 1. IS-1715 Typical Application Diagram
FN4875 Rev.5.00
Feb.4.21
Page 1 of 11
Copyright © 2000