5秒后页面跳转
IPS1025HF PDF预览

IPS1025HF

更新时间: 2024-11-13 14:57:55
品牌 Logo 应用领域
意法半导体 - STMICROELECTRONICS 开关驱动
页数 文件大小 规格书
36页 1688K
描述
高效的高侧开关,带扩展诊断和智能驱动(用于电容性负载),以及上电时的较短传播延迟

IPS1025HF 数据手册

 浏览型号IPS1025HF的Datasheet PDF文件第2页浏览型号IPS1025HF的Datasheet PDF文件第3页浏览型号IPS1025HF的Datasheet PDF文件第4页浏览型号IPS1025HF的Datasheet PDF文件第5页浏览型号IPS1025HF的Datasheet PDF文件第6页浏览型号IPS1025HF的Datasheet PDF文件第7页 
IPS1025HF  
Datasheet  
High efficiency, high-side switch with extended diagnostics, smart driving for  
capacitive loads and short propagation delay at power-on  
Features  
8.65 V to 60 V operating supply voltage range  
2.4 A operating output current  
Smart driving of capacitive load  
Fast demagnetization of inductive loads  
Under-voltage lock-out  
VCC over-voltage protection  
Output overload and over-temperature protection  
Case over-temperature protection  
Ground disconnection protection  
Overload and over-temperature event diagnostic pins  
Designed to meet IEC 61000-4-2, IEC 61000-4-4, IEC 61000-4-5  
Packages: PowerSSO-24 and VFQFPN-48L 8x6x0.9 mm  
Applications  
Programmable logic control  
Vending machines  
Industrial PC peripheral input/output  
Numerical control machines  
General high-side switch applications  
Description  
The IPS1025HF and are single high-side switch ICs able to drive capacitive, resistive  
or inductive loads with one side connected to ground.  
The 60 V operating range and RDS-ON = 12 mΩ (typ.), combined with the extended  
diagnostic (Over Load, Over-temperature) and the < 60 us propagation delay time at  
startup (enabling Class 3 for interface types C and D), make the IC suitable for  
applications implementing the proper architectures to address higher SIL levels.  
Product status link  
IPS1025HF  
Product label  
The very low RDS-ON (≤ 25 mΩ up to TJ = 125 °C) makes the IC suitable for the  
applications with up to 2.4 A steady state operating current.  
The output channel is protected against junction over-temperature events by a  
junction temperature sensor, and a further temperature sensor is included to monitor  
case temperature, so the overheated output channel can only be turned back ON  
when the case temperature returns below the reset temperature.  
The embedded overload protection circuit monitors the output current and, on  
triggering of the activation threshold (IPK), starts modulating the impedance of the  
output switch to limit the output current to ILIM, for both IC and load protection.  
The IC offers two different sets of activation threshold and limitation levels (IPKH  
,
ILIMH and IPKL, ILIML) for smart driving of capacitive loads (such as bulb lamps) and  
loads with initial peak current requirements.  
The IC diagnostics is based on FLT1 and FLT2 pins (both current source); activated  
by respective overload or overtemperature events on the output channel.  
DS13869 - Rev 5 - July 2023  
For further information contact your local STMicroelectronics sales office.  
www.st.com  

与IPS1025HF相关器件

型号 品牌 获取价格 描述 数据表
IPS102C-D-G-LF MICROSEMI

获取价格

Power Factor Controller
IPS102C-SO-G-LF MICROSEMI

获取价格

Power Factor Controller
IPS102C-SO-G-LF-TR MICROSEMI

获取价格

Micro Peripheral IC
IPS102I-D-G-LF MICROSEMI

获取价格

Power Factor Controller
IPS102I-SO-G-LF-TR MICROSEMI

获取价格

Micro Peripheral IC
IPS1031 INFINEON

获取价格

INTELLIGENT POWER LOW SIDE SWITCH
IPS1031R INFINEON

获取价格

INTELLIGENT POWER LOW SIDE SWITCH
IPS1031RTR INFINEON

获取价格

Peripheral Driver, 1 Driver, MOS
IPS1031RTRL INFINEON

获取价格

Half Bridge Based Peripheral Driver, 1 Driver, MOS, PSSO2, TO-252AA, DPAK, SMD-2
IPS1031RTRLPBF INFINEON

获取价格

Half Bridge Based Peripheral Driver, PSSO2, LEAD FREE, TO-252AA, DPAK, SMD-2