Datasheet > 1893BY-10T

1893BY-10T

更新时间： 2024-01-26 08:05:54

品牌	Logo	应用领域
艾迪悌 - IDT		以太网：16GBASE-T 电信电信集成电路
页数	文件大小	规格书
143页	1923K
描述
Ethernet Transceiver, 1-Trnsvr, CMOS, PQFP64, 10 X 10 MM, 1 MM HEIGHT, TQFP-64

阅读下载

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

1893BY-10T 技术参数

是否Rohs认证：	不符合	生命周期：	Obsolete
零件包装代码：	QFP	包装说明：	10 X 10 MM, 1 MM HEIGHT, TQFP-64
针数：	64	Reach Compliance Code：	not_compliant
HTS代码：	8542.39.00.01	风险等级：	5.83
数据速率：	100000 Mbps	JESD-30 代码：	S-PQFP-G64
JESD-609代码：	e0	长度：	10 mm
湿度敏感等级：	3	功能数量：	1
端子数量：	64	收发器数量：	1
最高工作温度：	70 °C	最低工作温度：
封装主体材料：	PLASTIC/EPOXY	封装代码：	HTFQFP
封装等效代码：	TQFP64,.47SQ	封装形状：	SQUARE
封装形式：	FLATPACK, HEAT SINK/SLUG, THIN PROFILE, FINE PITCH	峰值回流温度（摄氏度）：	240
电源：	3.3 V	认证状态：	Not Qualified
座面最大高度：	1.2 mm	子类别：	Network Interfaces
最大压摆率：	0.16 mA	标称供电电压：	3.3 V
表面贴装：	YES	技术：	CMOS
电信集成电路类型：	ETHERNET TRANSCEIVER	温度等级：	COMMERCIAL
端子面层：	TIN LEAD	端子形式：	GULL WING
端子节距：	0.5 mm	端子位置：	QUAD
处于峰值回流温度下的最长时间：	20	宽度：	10 mm
Base Number Matches：	1

1893BY-10T 数据手册

Integrated Circuit Systems, Inc.

DATA SHEET

Document Type: Data Sheet

ICS1893BY-10

Document Stage: Release

3.3-V 10Base-T/100Base-TX

Integrated PHYceiver™

3.3-V 10Base-T/100Base-TX Integrated PHYceiver™

General

Features

The ICS1893BY-10 is a low-power, physical-layer device

(PHY) that supports the ISO/IEC 10Base-T and 100Base-TX

Carrier-Sense Multiple Access/Collision Detection

(CSMA/CD) Ethernet standards. The ICS1893BY-10

supports managed or unmanaged node, repeater, and

switch applications.

• Supports category 5 cables with attenuation in excess of

24 dB at 100 MHz

• Fully integrated, DSP-based PMD includes:

– Adaptive equalization and baseline wander correction

– Transmit wave shaping and stream cipher scrambler

– MLT-3 encoder and NRZ/NRZI encoder

• Low-power, 0.35-micron CMOS (typically 400 mW)

• Power-down mode typically 21mW

• Single 3.3-V power supply.

The ICS1893BY-10 is intended for MII, Node applications

that require the Auto-MIDIX feature that automatically

corrects crossover errors in plant wiring.

• Single-chip, fully integrated PHY provides PCS, PMA,

PMD, and AUTONEG sublayers of IEEE standard

The ICS1893BY-10 incorporates digital signal processing

(DSP) in its Physical Medium Dependent (PMD) sublayer.

As a result, it can transmit and receive data on unshielded

twisted-pair (UTP) category 5 cables with attenuation in

excess of 24 dB at 100 MHz. With this ICS-patented

technology, the ICS1893BY-10 can virtually eliminate errors

from killer packets.

• 10Base-T and 100Base-TX IEEE 802.3 compliant

• Highly configurable design supports:

– Node, repeater, and switch applications

– Managed and unmanaged applications

– 10M or 100M half- and full-duplex modes

– Parallel detection

– Auto-negotiation, with Next Page capabilities

– Auto-MDI/MDIX crossover correction

The ICS1893BY-10 provides a Serial Management Interface

for exchanging command and status information with a

Station Management (STA) entity.

• MAC/Repeater Interface can be configured as:

– 10M or 100M Media Independent Interface

– 100M Symbol Interface (bypasses the PCS)

– 10M 7-wire Serial Interface

The ICS1893BY-10 Media Dependent Interface (MDI) can

be configured to provide either half- or full-duplex operation

at data rates of 10 MHz or 100 MHz. The MDI configuration

can be established manually (with input pins or control

Auto-Negotiation features). When the ICS1893BY-10

Auto-Negotiation sublayer is enabled, it exchanges

technology capability data with its remote link partner and

automatically selects the highest-performance operating

mode they have in common.

• Clock and crystal supported

• Small Footprint 64-pin Thin Quad Flat Pack (TQFP)

• Available in Industrial Temperature and Lead-Free

ICS1893BY-10 Block Diagram

100Base-T

PCS

•

Frame

CRS/COL

Detection

10/100 MII or

Alternate

MAC/Repeater

Interface

Twisted-

Pair

Interface to

Magnetics

Modules and

RJ45

Interface

MUX

Integrated

Switch

•

Parallel to Serial

4B/5B

10Base-T

Connector

MII

Low-Jitter

Clock

Synthesizer

Auto-

Negotiation

Configuration

and Status

Extended

Set

MII Serial

Management

Interface

Clock

Power

LEDs and PHY

Address

ICS reserves the right to make changes in the device data identified in

this publication without further notice. ICS advises its customers to

ICS1893BY-10 Rev A 3/24/04

March, 2004

IDT™ / ICS™ 3.3-V 10Base-T/100Base-TX Integrated PHYceiver™

ICS1893BY-10

obtain the latest version of all device data to verify that any information

being relied upon by the customer is current and accurate.

12 3 4 5 6 7...143

下载PDF

与1893BY-10T相关器件

型号	品牌	描述	获取价格	数据表
1893BYI-10	IDT	Ethernet Transceiver, 1-Trnsvr, CMOS, PQFP64, 10 X 10 MM, 1 MM HEIGHT, TQFP-64	获取价格
1893BYI-10T	IDT	Ethernet Transceiver, 1-Trnsvr, CMOS, PQFP64, 10 X 10 MM, 1 MM HEIGHT, TQFP-64	获取价格
1893C	RENESAS	3.3-V 10Base-T/100Base-TX Integrated PHYceiver?	获取价格
1893CF	IDT	Interface Circuit, 1-Trnsvr, CMOS, PDSO48, 0.300 MM INCH, SSOP-48	获取价格
1893CFI	IDT	Interface Circuit, 1-Trnsvr, CMOS, PDSO48, 0.300 MM INCH, SSOP-48	获取价格
1893CFILF	IDT	SSOP-48, Tube	获取价格

产品中心

服务支持

精选活动

关于我们

帮助中心

1893BY-10T

1893BY-10T 技术参数

1893BY-10T 数据手册

与1893BY-10T相关器件

与1893BY-10T相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

1893BY-10T

1893BY-10T 技术参数

1893BY-10T 数据手册

与1893BY-10T相关器件

与1893BY-10T相关文章

您还可以找

您在本页遇到什么问题？