5秒后页面跳转
捷配首页

Datasheet > ICS1893BY-10LF
ICS1893BY-10LF PDF预览

ICS1893BY-10LF

更新时间： 2024-09-27 11:14:19
品牌 Logo 应用领域
矽成 - ICSI /
页数 文件大小 规格书
143页 1665K
描述
3.3-V 10Base-T/100Base-TX Integrated PHYceiver

阅读下载

中文翻译

获取价格

ICS1893BY-10LF 数据手册

 浏览型号ICS1893BY-10LF的Datasheet PDF文件第2页浏览型号ICS1893BY-10LF的Datasheet PDF文件第3页浏览型号ICS1893BY-10LF的Datasheet PDF文件第4页浏览型号ICS1893BY-10LF的Datasheet PDF文件第5页浏览型号ICS1893BY-10LF的Datasheet PDF文件第6页浏览型号ICS1893BY-10LF的Datasheet PDF文件第7页 
Integrated Circuit Systems, Inc.  
Document Type: Data Sheet  
Document Stage: Release  
ICS1893BY-10  
3.3-V 10Base-T/100Base-TX Integrated PHYceiver™  
General  
Features  
The ICS1893BY-10 is a low-power, physical-layer device  
(PHY) that supports the ISO/IEC 10Base-T and 100Base-TX  
Carrier-Sense Multiple Access/Collision Detection  
(CSMA/CD) Ethernet standards. The ICS1893BY-10  
supports managed or unmanaged node, repeater, and  
switch applications.  
• Supports category 5 cables with attenuation in excess of  
24 dB at 100 MHz  
• Fully integrated, DSP-based PMD includes:  
– Adaptive equalization and baseline wander correction  
– Transmit wave shaping and stream cipher scrambler  
– MLT-3 encoder and NRZ/NRZI encoder  
• Low-power, 0.35-micron CMOS (typically 400 mW)  
• Power-down mode typically 21mW  
• Single 3.3-V power supply.  
The ICS1893BY-10 is intended for MII, Node applications  
that require the Auto-MIDIX feature that automatically  
corrects crossover errors in plant wiring.  
• Single-chip, fully integrated PHY provides PCS, PMA,  
PMD, and AUTONEG sublayers of IEEE standard  
The ICS1893BY-10 incorporates digital signal processing  
(DSP) in its Physical Medium Dependent (PMD) sublayer.  
As a result, it can transmit and receive data on unshielded  
twisted-pair (UTP) category 5 cables with attenuation in  
excess of 24 dB at 100 MHz. With this ICS-patented  
technology, the ICS1893BY-10 can virtually eliminate errors  
from killer packets.  
• 10Base-T and 100Base-TX IEEE 802.3 compliant  
• Highly configurable design supports:  
– Node, repeater, and switch applications  
– Managed and unmanaged applications  
– 10M or 100M half- and full-duplex modes  
– Parallel detection  
– Auto-negotiation, with Next Page capabilities  
– Auto-MDI/MDIX crossover correction  
The ICS1893BY-10 provides a Serial Management Interface  
for exchanging command and status information with a  
Station Management (STA) entity.  
• MAC/Repeater Interface can be configured as:  
– 10M or 100M Media Independent Interface  
– 100M Symbol Interface (bypasses the PCS)  
– 10M 7-wire Serial Interface  
The ICS1893BY-10 Media Dependent Interface (MDI) can  
be configured to provide either half- or full-duplex operation  
at data rates of 10 MHz or 100 MHz. The MDI configuration  
can be established manually (with input pins or control  
register settings) or automatically (using the  
Auto-Negotiation features). When the ICS1893BY-10  
Auto-Negotiation sublayer is enabled, it exchanges  
technology capability data with its remote link partner and  
automatically selects the highest-performance operating  
mode they have in common.  
• Clock and crystal supported  
• Small Footprint 64-pin Thin Quad Flat Pack (TQFP)  
• Available in Industrial Temperature and Lead-Free  
ICS1893BY-10 Block Diagram  
100Base-T  
PCS  
•
•
Frame  
CRS/COL  
Detection  
10/100 MII or  
Alternate  
MAC/Repeater  
Interface  
Twisted-  
Pair  
Interface to  
Magnetics  
Modules and  
RJ45  
Interface  
MUX  
Integrated  
Switch  
•
•
Parallel to Serial  
4B/5B  
10Base-T  
Connector  
MII  
Low-Jitter  
Clock  
Synthesizer  
Auto-  
Negotiation  
Configuration  
and Status  
Extended  
Register  
Set  
MII Serial  
Management  
Interface  
Clock  
Power  
LEDs and PHY  
Address  
ICS reserves the right to make changes in the device data identified in  
this publication without further notice. ICS advises its customers to  
obtain the latest version of all device data to verify that any information  
being relied upon by the customer is current and accurate.  
ICS1893BY-10 Rev A 3/24/04  
March, 2004  
1234567...143

中文翻译

下载PDF

与ICS1893BY-10LF相关器件

型号 品牌 获取价格 描述 数据表
ICS1893BY-10T IDT

获取价格

 		Ethernet Transceiver, 1-Trnsvr, CMOS, PQFP64, 10 X 10 MM, 1 MM HEIGHT, TQFP-64
ICS1893BYI-10 ICSI

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceiver
ICS1893BYI-10LF ICSI

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceiver
ICS1893BYI-10LFT IDT

获取价格

 		Ethernet Transceiver, 1-Trnsvr, CMOS, PQFP64, 10 X 10 MM, 1 MM HEIGHT, LEAD FREE, TQFP-64
ICS1893BYI-10T IDT

获取价格

 		Ethernet Transceiver, 1-Trnsvr, CMOS, PQFP64, 10 X 10 MM, 1 MM HEIGHT, TQFP-64
ICS1893CF ICSI

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceive
ICS1893CF IDT

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceive
ICS1893CFI IDT

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceive
ICS1893CFI ICSI

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceive
ICS1893CFILF IDT

获取价格

 		3.3-V 10Base-T/100Base-TX Integrated PHYceive

与ICS1893BY-10LF相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证