Supertex inc.
HV2321
Low Charge Injection, 8-Channel, Unipolar,
Negative High Voltage, Analog Switch With Bleed Resistors
Features
► Low on-resistance, 14Ω max.
General Description
The Supertex HV2321 is a low charge injection, 8-channel,
unipolar, negative high voltage, analog switch integrated circuit
(IC) with bleed resistors. The device can be used in applications
requiring high voltage switching controlled by low voltage signals,
such as NDT metal flaw detection, medical ultrasound imaging,
piezoelectric transducer drivers, and printers. The bleed resistors
eliminate voltage built up on capacitive loads such as piezoelectric
transducers.
► Integrated bleed resistors on the outputs
► 3.3 or 5.0V CMOS input logic level
► 20MHz data shift clock frequency
► Very low quiescent power dissipation (-10µA)
► Low parasitic capacitance
► DC to 50MHz small signal frequency response
► -60dB typical off-isolation at 5.0MHz
► CMOS logic circuitry for low power
► Excellent noise immunity
Data is input into an 8-bit shift register and then retained in an 8-bit
latch. To reduce any possible clock feed-through noise, the latch
enable bar should be left high until all bits are clocked in. Data is
clocked in during the rising edge of the clock.
► Cascadable serial data register with latches
Applications
► NDT metal flaw detection
► Medical ultrasound imaging
► Piezoelectric transducer drivers
► Inkjet printer heads
Using HVCMOS technology, this device combines high voltage
bilateral DMOS switches and low power CMOS logic to provide
efficient control of high voltage analog signals.
► Optical MEMS modules
Block Diagram
Level
Shifters
Output
Switches
Latches
D
LE
CLR
SW0
SW1
SW2
D
LE
CLR
CLK
8-Bit
Shift
D
LE
CLR
Register
DIN
DOUT
D
LE
CLR
SW6
SW7
D
LE
CLR
VDD GND
LE CLR
VNN VPP
RGND
Supertex inc. ● 1235 Bordeaux Drive, Sunnyvale, CA 94089 ● Tel: 408-222-8888 ● www.supertex.com