HS-0546RH, HS-0547RH
Data Sheet
August 1999
File Number 3544.2
Radiation Hardened Single 16/Differential
8 Channel CMOS Analog Multiplexers with
Active Overvoltage Protection
Features
• Electrically Screened to SMD # 5962-95693
• QML Qualified per MIL-PRF-38535 Requirements
The HS-0546RH and HS-0547RH are radiation hardened
analog multiplexers with Active Overvoltage Protection and
4
• Gamma Dose . . . . . . . . . . . . . . . . . . . . . . 1 x 10 RAD(Si)
guaranteed r
matching. Analog input levels may greatly
ON
• No Latch-Up
exceed either power supply without damaging the device or
disturbing the signal path of other channels. Active protection
circuitry assures that signal fidelity is maintained even under
fault conditions that would destroy other multiplexers. Analog
inputs can withstand constant 70V peak-to-peak levels with
±15V supplies and digital inputs will sustain continuous faults
up to 4V greater than either supply. In addition, signal sources
are protected from short circuiting should multiplexer supply
loss occur: each input presents 1kΩ of resistance under this
condition. These features make the HS-0546RH and
• No Channel Interaction During Overvoltage
• Guaranteed r
Matching
ON
• Maximum Power Supply. . . . . . . . . . . . . . . . . . . . . . . .44V
• Break-Before-Make Switch
• Analog Signal Range. . . . . . . . . . . . . . . . . . . . . . . . . . . .±15V
• Access Time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0µs
HS-0547RH ideal for use in systems where the analog inputs
originate from external equipment or separately powered
circuitry. Both devices are fabricated with 44V dielectrically
isolated CMOS technology. The HS-0546 is a 16 channel
device and the HS-0547 is an 8 channel differential version. If
input overvoltage protection is not needed, the HS-0506 and
HS-0507 multiplexers are recommended.
Applications
• Data Acquisition Systems
• Control Systems
• Telemetry
Ordering Information
Specifications for Rad Hard QML devices are controlled
by the Defense Supply Center in Columbus (DSCC). The
SMD numbers listed here must be used when ordering.
INTERNAL
MKT. NUMBER
TEMP. RANGE
o
ORDERING NUMBER
5962D9569301V9A
5962D9569301VXA
5962D9569301VXC
5962D9569302V9A
5962D9569302VXA
5962D9569302VXC
( C)
HS0-0546RH-Q
HS1-0546RH-Q
HS1B-0546RH-Q
HS0-0547RH-Q
HS1-0547RH-Q
HS1B-0547RH-Q
25
-55 to 125
-55 to 125
25
Detailed Electrical Specifications for these devices are
contained in SMD 5962-95693. A “hot-link” is provided
on our homepage for downloading.
-55 to 125
-55 to 125
http://www.intersil.com/spacedefense/space.htm
Pinouts
HS-0546RH GDIP1-T28 (CERDIP) OR CDIP2-T28 (SBDIP)
HS-0547RH GDIP1-T28 (CERDIP) OR CDIP2-T28 (SBDIP)
TOP VIEW
TOP VIEW
V
1
2
3
4
5
6
7
8
9
28 OUT
27 -V
+V
1
2
3
4
5
6
7
8
9
28 OUT A
27 -V
SUPPLY
NC
SUPPLY
OUT B
SUPPLY
SUPPLY
26 IN 8
25 IN 7
24 IN 6
23 IN 5
22 IN 4
21 IN 3
26 IN 8A
25 IN 7A
24 IN 6A
23 IN 5A
22 IN 4A
21 IN 3A
NC
IN 16
IN 15
IN 14
IN 13
IN 12
IN 11
NC
IN 8B
IN 7B
IN 6B
IN 5B
IN 4B
IN 3B
20
20
IN 2A
IN 2
IN 10 10
IN 9 11
GND 12
19 IN 1
IN 2B 10
IN 1B 11
GND 12
19 IN 1A
18 ENABLE
18 ENABLE
17 ADDRESS A0
16 ADDRESS A1
15 ADDRESS A0
17 ADDRESS A0
16 ADDRESS A1
15 ADDRESS A2
V
13
V
13
REF
REF
ADDRESS A3 14
NC 14
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
http://www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999
1