Applicable standard
Operating
Storage
-55 °C to +85 °C ( 95 %RH Max.)
-55 °C to +85 °C ( 95 %RH Max.)
temperature range
temperature range
Characteristic
impedance
Applicable
cable
-- W
----
Ω(
to
GHz)
Rating Power
----
Peculiarity
SPECIFICATIONS
TEST METHOD
ITEM
REQUIREMENTS
QT AT
CONSTRUCTION
General examination
Marking
Visually and by measuring instrument.
Confirmed visually.
According to drawing.
X
X
X
X
ELECTRICAL CHARACTERISTICS
Contact resistance
-- mA Max.(DC or 1000 Hz)
Center contact --- mΩ Max.
Outer contact --- mΩ Max.
--- MΩ Min.
-
-
-
-
-
-
-
-
Insulation resistance
Withstanding voltage
Voltage standing
wave ratio
--- V DC.
--- V AC for 1 min. current leakage 2 mA Max.
Frequency - to - GHz.
Frequency - to - GHz.
No flashover or breakdown.
VSWR --- Max.
VSWR --- Max.
-
-
-
-
Insertion loss
Frequency - to - GHz.
--- dB Max.
MECHANICAL CHARACTERISTICS
Contact insertion and
extraction forces
Insertion and
φ
--- by steel gauge.
Insertion force
Extraction force --- N Min.
Insertion force --- N Max.
--- N Max.
-
-
-
-
-
-
-
-
Measured by applicable connector.
--- times insertion and extractions.
extraction forces
Mechanical operation
Extraction force --- N Min.
1)Contact resistance:
Center contact --- mΩ Max.
Outer contact --- mΩ Max.
-
-
2)No damage, crack and looseness of parts.
1)No electrical discontinuity of 1 μs.
2)No damage, crack and looseness of parts.
Vibration
Shock
Frequency --- to --- Hz single amplitude --- mm,
--- m/s2 at --- cycles for --- directions.
--- m/s2 directions of pulse --- ms
-
-
-
-
at --- times for --- directions.
Cable clamp strength
(Against cable pull)
Using a pulling tester, pull the cable axially at a rate
of --- mm/min. and record the strength at which
the cable or connector breaks.
--- N Min.
-
-
ENVIRONMENTAL CHARACTERISTICS
Damp heat
Exposed at --- to --- °C, --- to --- %
total --- cycles.( -- h)
1)Insulation resistance: --- MΩ Min.
(at high humidity)
2) Insulation resistance: --- MΩ Min.
(at dry)
-
-
3)No damage, crack and looseness of parts.
No damage, crack and looseness of parts.
Rapid change of
temperature
Temperature
Time
- → - →
- → - →
- →
- →
- °C
- min.
-
-
-
Under --- cycles.
Corrosion salt mist
Exposed in 5 % salt water spray for 48 h.
No heavy corrosion.
X
Count
0
Description of revisions
Designed
Checked
Date
TO.KATAYAMA
KY.SHIMIZU
SR.AIHARA
SR.AIHARA
18.06.13
18.06.12
18.06.12
18.06.12
Remark
Approved
Checked
Designed
Drawn
Unless otherwise specified, refer to IEC 60512.
Note QT:Qualification Test AT:Assurance Test X:Applicable Test
Drawing No.
Part No.
ELC-005507-40-00
HRM-514(40)
SPECIFICATION SHEET
0
1/1
HIROSE ELECTRIC CO., LTD.
Code No.
CL323-0038-1-40
FORM HD0011-2-1