HI-6010
ARINC 429 TRANSMITTER/RECEIVER FOR 8 BIT BUS
January 2006
GENERAL DESCRIPTION
FEATURES
The HI-6010 is a CMOS integrated circuit designed to
interface the avionics data bus standard ARINC 429 to an
8 bit port. It contains one receiver and one transmitter.
They operate independently except for the self test option
and the parity option. The receiver demands that the
incoming data meet the standard protocol and the trans-
mitter outputs a standard protocol stream.
!
ARINC 429 protocol controller with interface to
an 8 bit bus
!
!
!
!
!
Automatic label recognition option
8 bit or 32 bit buffering option
Self test and parity options
CMOS / TTL logic pins
The HI-6010 provides flexible options for interfacing to the
user system. The controlling processor can operate both
the receiver and transmitter either by using hard wired
flags and gates at the pins or by using software reads and
writes of the Status Register and Control Register or a
combination thereof.
Plastic and ceramic package options - surface
mount or DIP
!
Military processing available
The chip is programmable to operate with single 8 bit
bytes requiring "on the fly transmitter loading and receiver
downloading" or to operate in 32 bit "extended buffer"
mode. In addition there is an option to use automatic label
recognition after loading 8 possible labels for comparison.
Parity and self test are also software programmable.
Master Reset is activated only by taking the MR pin high.
PIN CONFIGURATION (Top View)
VSS
WEF
1
2
3
4
5
6
7
8
9
28 RE
27 C/D
26 CS
25 WE
24 D7
23 D6
22 D5
21 D4
20 D3
19 D2
18 D1
17 D0
16 RXD1
15 VDD
CTS
TXC
HFS
Two clock inputs allow independent selection of the data
rates of the transmitter and receiver. Each must be 4X the
desiredARINC 429 frequency.
MR
TXE
RXRDY
TXRDY
Error flags are generated for transmitter underwrites and
for receiver data framing miscues, parity errors, and buffer
overwrites.
TXD0 10
TXD1 11
RXC 12
FCR 13
RXD0 14
The HI-6010 is a 5 volt chip that will require data transla-
tion from and to theARINC bus. The HI-8482 and HI-8588
line receivers are available for the receiver side and the
HI-318X and HI-858X line drivers are available for the
transmitter side.
Pin numbers apply for plastic and ceramic DIP and
for plastic PLCC. Consult factory for pin out of 48
lead ceramic leadless chip carrier.
APPLICATIONS
OPERATING SUPPLY VOLTAGE
! Avionics Data Communication
! Serial to Parallel Conversion
! Parallel to Serial Conversion
! VDD = 5.0 VOLTS 5%
! VSS = 0.0 VOLTS
HOLT INTEGRATED CIRCUITS
www.holtic.com
(DS6010 Rev.D)
01/06