Spec. No. : Preliminary Data
Issued Date : 1998.08.01
Revised Date : 2001.01.30
Page No. : 1/3
HI-SINCERITY
MICROELECTRONICS CORP.
H7808AM
H7808BM
Low Current Positive Voltage Regulator Of Surface Mount Device
Description
The H7808_M series of surface mount device regulators are easy-
to-use devices suitable for multitude of applications that require a
regulated supply of up to 100mA. These regulators feature internal current limiting and thermal
shutdown making them remarkably rugged. No external components are required with the 780-
8_M devices in many applications.
These devices offer a substantial performance advantage over the traditional zener diode
resistor combination, as output impedance and quiescent current are substantially reduced.
• Wide Range Of Available, Fixed Output Voltages
• Internal Short-Circuit Current Limiting
• Internal Thermal Overload Protection
• No External Components Required
(Ta=25°C)
Absolute Maximum Ratings
• Input Voltage................................................... 30 V (5V Through 9V), 35 V (12V Through 18V)
• Total Power Dissipation ........................................................................................... Internal limit
• Operating Temperature Range ............................................................................ 0 °C to +70 °C
• Maximum Junction Temperature...................................................................................... 125 °C
• Storage Temperature Range .......................................................................... -55 °C to +150 °C
• Lead Temperature (Soldering 10S).................................................................................. 260 °C
Typical Application
Schematic Diagram
Vin
Vin
Vout
C2
5K
3
1
H7808_M
5.7K
100
2
1.5K 1.9K
Vout
100
576
C1
5pF
3.41K
13K
3.89K
7.8K
2.23K
A common ground is required between the input
and the output voltages. The input voltage must
remain typically 2.0V above the output voltage
even during the low point on the input ripple
voltage.
2.84K
GND
Note : C1 and C2 are required if regulator is
located far from power supply filter and load, or
oscillation may induced on the loop
H7808AM, H7808BM
HSMC Product Specification