GS –702
Flexible Remote Control (FRC) Technology ™ Transmitter
GENERAL DESCRIPTION
The GS 702 transmitter controller has been designed in order to meet the requirements of
replacement remote control makers. It’s structure is based on Application Specific Programmable
Micro-controller with a super parallel architecture implemented by means of CMOS EPROM
technology.
GS 702 replaces most of the original transmitter ICs, used nowadays. Additionally, many
parameters and functional features have been dramatically improved. A typical remote control
implementation, shown on Fig 1 uses only four external components, and power consumption
in stand-by mode is in the range of 100nA.
In order to facilitate application project design for different type of protocols, a FRC CAD system
and Chip Programmer are available. The CAD library contains more than 30 of most popular
protocols, at present, and new ones could be developed and added by the user.
GS 702 Transmitter Pin Description
Pin No
1
Symbol
OSC0
Description
Oscillator Output
2
OSC1
Oscillator Input
3-10
11
OUT0-OUT7
VPP
Key Outputs
Programming Voltage
12
GND
Ground
13
WRD
Terminal for Test and EPROM Programming
Terminal for Test and EPROM Programming
Key Inputs, Internally Pull Down to GND
Remote Output
14
PGM
15-22
23
IN0-IN7
REM
24
VCC
Positive Supply
o
Electrical Characteristics (T =25 C)
a
PARAMETER SYMBOL CONDITIONS
Supply Voltage VCC
Supply Current ICC
Output Current IREM
MIN TYP MAX UNIT
2.2
3.3
1
V
VCC=3V,Standby
VCC=2.2V
0.1
uA
10
mA
kOhm
Input Pull Down R
Rio
VCC=3V
20
GS 702 Specific Characteristics
Key matrix:
- 64 (8 X 8) buttons.
- 400 ÷550 kHz
- flash or modulated.
- 3 ÷ 5 sec.
- DIL24, SOP24 and COB (Chip–On–Board)
Ceramic resonator used:
Transmission modes:
Programming Time:
Packages available: