Tiny I2C Programmable Linear Battery Charger
with Power Path and USB Mode Compatibility
Data Sheet
ADP5061
FEATURES
TYPICAL APPLICATION CIRCUIT
2.6 mm × 2 mm WLCSP package
ADP5061
SYSTEM
Fully programmable via I2C
ISO_S
VBUS
VIN
AC OR
USB
CBP
C3
47µF
Flexible digital control inputs
C1
10µF
C2
10nF
Up to 2.1 A current from an ac charger in LDO mode
Operating input voltage from 4.0 V to 6.7 V
Tolerant input voltage from −0.5 V to +20 V (USB VBUS)
Fully compatible with USB 3.0 and USB Battery Charging
Specification 1.2
SCL
SDA
ISO_B
CHARGER
CONTROL
BLOCK
C4
22µF
BAT_SNS
DIG_IO1
DIG_IO2
DIG_IO3
Li-ion
+
THR
Built-in current sensing and limiting
SYS_EN
As low as 30 mΩ battery isolation FET between battery and
charger output
ILED
VLED
AGND
Thermal regulation prevents over heating
Compliant with JEITA 1 and JEITA 2 Li-Ion battery charging
temperature specifications
Figure 1.
SYS_EN flag permits the system to be disabled until battery is at
minimum required level for guaranteed system start-up
APPLICATIONS
Digital still cameras
Digital video cameras
Single cell Li-Ion portable equipment
PDAs, audio, and GPS devices
Portable medical devices
Mobile phones
GENERAL DESCRIPTION
scenario, which allows for immediate system function on connec-
tion to a USB power supply.
The ADP5061 charger is fully compliant with USB 3.0 and the
USB Battery Charging Specification 1.2 and enables charging
via the mini USB VBUS pin from a wall charger, car charger, or
USB host port.
Based on the type of USB source, which is detected by an external
USB detection chip, the ADP5061 can be set to apply the correct
current limit for optimal charging and USB compliance.
The ADP5061 operates from a 4 V to 6.7 V input voltage range
but is tolerant of voltages up to 20 V. The 20 V voltage tolerance
alleviates the concerns about the USB bus spiking during dis-
connect or connect scenarios.
The ADP5061 has three factory programmable digital input/output
pins that provide maximum flexibility for different systems.
These digital input/output pins permit combinations of features
such as, input current limits, charging enable and disable,
charging current limits, and a dedicated interrupt output pin.
The ADP5061 features an internal FET between the linear
charger output and the battery. This permits battery isolation
and, hence, system powering under a dead battery or no battery
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rightsof third parties that may result fromits use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks andregisteredtrademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Fax: 781.461.3113
www.analog.com
©2012 Analog Devices, Inc. All rights reserved.