Global Mixed-mode Technology Inc.
G692/G693
4-Pin µP Voltage Monitors with Manual Reset Input
Features
General Description
ꢀPrecision Monitoring of +3V, +3.3V, and +5V
Power-Supply Voltages
The G692/G693 are microprocessor (µP) supervisory
circuits used to monitor the power supplies in µP and
digital systems. They provide excellent circuit reliability
and low cost by eliminating external components and
adjustments when used with +5V, +3.3V, +3.0V- pow-
ered circuits. The G692/G693 also provide a de-
bounced manual reset input.
ꢀFully Specified Over Temperature
ꢀAvailable in Three Output Configurations
Push-Pull RESET Output (G692L)
Push-Pull RESET Output (G692H)
Open-Drain RESET Output (G693L)
ꢀ140ms min Power-On Reset Pulse Width
ꢀ5µA Supply Current
These circuits perform a single function: they assert a
reset signal whenever the VCC supply voltage declines
below a preset threshold, keeping it asserted for at
least 140ms after VCC has risen above the reset
threshold. Reset thresholds suitable for operation with
a variety of supply voltages are available.
ꢀGuaranteed Reset Valid to VCC = +1V
ꢀPower Supply Transient Immunity
ꢀNo External Components
ꢀManual Reset Input
ꢀ4-Pin SOT143 Package
The G693L has an open-drain output stage, while the
G692 have push-pull outputs. The G693L’s open-drain
Applications
RESET output requires a pull-up resistor that can be
connected to a voltage higher than VCC. The G692L
have an active-low RESET output, while the G692H
has an active-high RESET output. The reset com-
parator is designed to ignore fast transients on VCC
and the outputs are guaranteed to be in the correct
logic state for VCC down to 1V.
ꢀComputers
ꢀControllers
ꢀIntelligent Instruments
ꢀCritical µP and µC Power Monitoring
ꢀPortable / Battery-Powered Equipment
ꢀAutomotive
,
Low supply current makes the G692/G693 ideal for
use in portable equipment. The G692/G693 are avail-
able in a 4-pin SOT143 packages.
Ordering Information
PART
G692H(L)xxxTC -40°C ~ +105°C
G693LxxxTC -40°C ~ +105°C
* xxx specifies the threshold voltage.
TEMP. RANGE
PIN-PACKAGE
SOT143
SOT143
e.g. 263 denotes the 2.63V threshold voltage.
Pin Configuration
Typical Operating Circuit
VCC
VCC
GND
4
3
1
VCC
VCC
RPULL-UP
*
G692/G693
G692/G693
SOT143
µP
RESET
RESET
MR
INPUT
(RESET)
MR
GND
RESET(RESET)
()is for G692H
2
GND
*G693 ONLY
TEL: 886-3-5788833
http://www.gmt.com.tw
Ver: 1.0
Sep 23, 2002
1