G529
Global Mixed-mode Technology
Power Switch for MHL
Features
General Description
70mΩ High-Side MOSFET
The G529 is an integrated power switch for
self-powered and bus-powered Universal Serial Bus
(USB) applications. RDS(ON) is 70mΩ.
Current Limit for MHL Power Switch
Operating Range:2.7V to 5.5V
1mS Typical Rise Time
Fast Overcurrent Response -3µs (TYPICAL)
Under voltage Lockout
130µA Quiescent Supply Current
1µA Maximum Shutdown Supply Current
Logic Level Enable Pin, Available with
Active-High or Active-Low Version
No Reverse Current when Power Off
Deglitched Open-Drain Over-Current Flag
Several Protection features include current limiting and
thermal shutdown to prevent catastrophic switch fail-
ure caused by increasing power dissipation when con-
tinuous heavy loads or short circuit occurs. A built-in
charge pump is used to drive the N-channel MOSFET
that is free of parasitic body diode to eliminate any
reversed current flow across the switch when it is pow-
ered off. When the output voltage is higher than input
voltage, the power switch is turned off by internal out-
put reverse-voltage comparator.
Output ( OC )
Output Reverse-Voltage Protection
SOT-23-6 Packages
OC is open-drain output report over-current or
over-temperature event and has typical 9ms deglitch
Applications
timeout period. In addition, OC also reports output
reverse-voltage condition with typical 5ms deglitch
timeout period.
MHL Power Switch
High-Side Power Protection Switch
USB Power Management
USB Host and Self-Powered Bubs
USB Bus-Powered Hubs
Hot Plug-In Power Supplies
Battery-Charger Circuits
Ordering Information
Output
ORDER
MARKING
NUMBER
Current
Limit
TEMP.
RANGE
PACKAGE
(Green)
ENABLE
Shutdown
Resistor
No
G529A1TB1U
G529A2TB1U
529Ax
529Bx
Active High
Active Low
1.2A
1.2A
-40oC to +85oC
-40oC to +85oC
SOT-23-6
SOT-23-6
No
Note: TB: SOT-23-6
1: Bonding Code
U: Tape & Reel
Pin Configuration
Typical Application Circuit
G529
G529
Power Supply
2.7V to 5.5V
IN
OUT
Load
EN (EN)
GND
IN
1
2
3
6
5
OC
*
1µF
22µF
0.1µF
OC
OUT
EN(EN)
ON
OFF
OUT
4
SOT-23-6
*: 1µF of input capacitor is enough in most application cases.
If the PCB trace of power rail to IN is long, larger input capacitor is necessary.
TEL: 886-3-5788833
Ver: 0.4
http://www.gmt.com.tw
Mar 27, 2013
1