Global Mixed-mode Technology Inc.
G525
USB High-Side Power Switch Advance Information
Features
General Description
The G525 is an integrated high-side power switch op-
timized for self-powered and bus-powered Universal
Serial Bus (USB) applications.
Compliant to USB standard
Typical 130mΩ, Low MOSFET on resistance, at
5.0V
500mA minimum continuous load current
3.0V to 5.5V operating range
100µA typical on-state supply current
25µA typical standby supply current
Output can be forced higher than input when
operating in off state.
The G525 satisfies the USB standards. The switch's
low on-resistance meets USB voltage drop require-
ments. When the output load exceeds current-limit
threshold, G525 switches into constant mode and limit
the output current to a safe level, which is typically
900mA, well below the UL 25VA safety requirement. An
open-drain flag output is also available to indicate fault
conditions to the local USB controller. Soft start elimi-
nates the momentary voltage drop on the upstream
port that may occur when the switch is enabled in
bus-powered applications.
1.2A maximum current limit
Thermal shutdown protection
2.4V typical undervoltage lockout (UVLO)
Open-drain fault flag pin
Slow turn-on (soft-start) and fast turnoff
Logic level enable pin, available with active-
high or active-low version
Besides, a thermal shutdown circuit is included to pre-
vent catastrophic switch failure caused by increasing
power dissipation when continuous heavy loads or
short circuit occurs. A undervoltage lockout (UVLO)
circuit ensures that the device remains off unless there
is a valid input voltage present, and an enable input
that is compatible with both 3.3V and 5V logic.
Applications
High-side power protection switch
USB power management
USB host and self-powered hubs
USB Bus-powered hubs
Hot plug-in power supplies
Battery-charger circuits
Ordering Information
ORDER
NUMBER
G525-1
PACKAGE
(Pb free)
SOP-8
MARKING
ENABLE
TEMP. RANGE
G525-1
G525-2
G525-1
G525-2
Active High
Active Low
Active High
Active Low
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
-40°C to +85°C
G525-2
SOP-8
G525-1P81U
G525-2P81U
MSOP-8
MSOP-8
Note: P1: SOP-8
1: Bonding Code
U: Tape & Reel
P8: MSOP-8
Pin Configuration
Function Block
G525
G525
EN
FLG
GND
NC
1
2
3
4
8
7
6
5
OUT
6,8 (OUT)
7 (IN)
IN
(EN) 1
Gate
Control
(FLG) 2
OUT
NC
3 (GND)
SOP-8/MSOP-8
TEL: 886-3-5788833
http://www.gmt.com.tw
Ver 2.2
Mar 19, 2008
1