G2002/G2002B
Global Mixed-mode Technology
5+1CH serial input motor driver IC for DSC
Features
General Description
Build-in one micro-steps drive mode is possible
from 2-2 phase stepper drive to maximum 256
resolution micro-steps.
Built in 2 full-swing/constant voltage drivers
switched by serial control with brake function
Built in 1 constant current drivers for shutter or
IRIS
Low on-resistance (1.2Ω, sum of on-resistance of
upside and bottom side)
Output current:IOUT<=0.8A(max.) for each channel
G2002/G2002B is a 5+1-channel H-Bridge motor
drivers IC for the digital camera and so on. It has one
micro-stepping driver, two full-swing/constant voltage
drivers and one full-swing/constant current drivers. G2002
/G2002B can be operated in serial control mode or
partial exterior control mode. When operating in partial
exterior control mode, the mode of each CH is fixed by
initial serial control setting. When operating in serial
control mode, the mode of each driver can be setting
by serial control.
Build-in thermal shutdown (TSD, 150°C)
All power supply systems (VCC, VM12, VM3,
VM45) can be set up with an independent power
supply
Power save mode corresponds by serial control
setup
PI (photo interrupter drive) 3 channel built-in.
Small 28TQFN (4×4mm) is adopted
Build-in POR (power on reset).
Ordering Information
ORDER
NUMBER
TEMP.
RANGE
PACKAGE
(Green)
MARKING
G2002RV1U
2002
-20°C to +85°C TQFN4X4-28
-20°C to +85°C TQFN4X4-28
G2002BRV1U
2002B
Applications
Stepping motor driver/ DC motor driver motor
driver for DSC
Note: RV: TQFN4X4-28
1: Bonding Code
U: Tape & Reel
Pin Configurations
RNF5
OUT5B
VM45
OUT4A
P13
21
20
19
18
17
1
2
OUT1A
OUT1B
3
4
CH12:Micro_stepping
VM12
Thermal
Pad
(PGND12,PGND3)
OUT2A
CH3 :CV/FS
CH4 :CV/FS
CH5 :CC only
OUT2B
5
16
15
OUT4B
P11
OUT3A
OUT3B
6
7
G2002/G2002B TQFN4X4-28
Note: Recommend connecting the Thermal Pad to
the Ground for excellent power dissipation.
Ver: 0.6
May 08, 2012
TEL: 886-3-5788833
http://www.gmt.com.tw
1