Global Mixed-mode Technology
G2001
6+1CH serial input motor driver IC for DSC
Features
General Description
Build-in two micro-steps drive mode is possible
from 2-2 phase stepper drive to maximum 256
resolution micro-steps.
Built in 2 full-swing/constant voltage/constant
current drivers switched by serial control with
brake function
G2001 is a 6+1-channel H-Bridge motor drivers IC for the
digital camera and so on. It has two micro-stepping drivers,
two full-swing/constant voltage/constant current drivers.
G2001 can be operated in serial control mode or partial
exterior control mode. When operating in partial exterior
control mode, the mode of each CH is fixed by initial
serial control setting. When operating in serial control
mode, the mode of each driver can be setting by serial
control.
Low on-resistance (1.2Ω, sum of on-resistance of
upside and bottom side)
Output current:IOUT<=0.8A(max.) for each channel
Build-in thermal shutdown (TSD, 150°C)
All power supply systems (VCC, VM12, VM34,
VM5, VM6) can be set up with an independent
power supply
Power save mode corresponds by serial control
setup
PI (photo interrupter drive) 3 channel built-in.
Small 40TQFN (5×5mm) is adopted
Build-in POR (power on reset).
Ordering Information
ORDER
NUMBER
TEMP.
RANGE
PACKAGE
(Green)
MARKING
G2001RG1U
2001
-20°Cto+85°C TQFN5X5-40
Note: RG: TQFN5X5-40
1: Bonding Code
Applications
Stepping motor driver/ DC motor driver motor
driver for DSC
U: Tape & Reel
Pin Configurations
CH12:Micro_stepping
CH34:Micro_stepping
CH5: CC/CV/FS
1
30 IN3
MOB1 / SDO
29
28
27
26
2
3
IN4
EXT1 / ST1
SLD
OUT2B
4
PGND12
SCLK
SDAT
5
OUT2A
VM12
CH6: CC/CV/FS
Thermal
Pad
6
25 VM5
7
OUT1B
PGND12
OUT1A
GND
24 OUT5A
23
8
RNF5
22
21
9
OUT5B
PI3
10
G2001 TQFN5X5-40
Note: Thermal Pad must connect to the Ground for excellent power dissipation.
Ver: 0.6
Dec 20, 2012
TEL: 886-3-5788833
http://www.gmt.com.tw
1