FT221X USB 8-BIT SPI/FT1248 IC Datasheet
Version 1.3
Document No.: FT_000630 Clearance No.: FTDI# 263
Future Technology Devices
International Ltd
.
FT221X
(USB 8-Bit SPI/FT1248 IC)
USB Battery Charger Detection. Allows for USB
peripheral devices to detect the presence of a
higher power source to enable improved
charging.
The FT221X is a USB to FTDI’s
proprietary FT1248 interface with the
following advanced features:
Single chip USB to 1, 2, 4, or 8 bit wide
synchronous interface.
Device supplied pre-programmed with unique
USB serial number.
Similar to an SPI Slave with variable bus width.
USB Power Configurations; supports bus-
powered, self-powered and bus-powered with
power switching.
Entire USB protocol handled on the chip. No
USB specific firmware programming required.
Integrated +3.3V level converter for USB I/O.
Fully
integrated
2048
byte
multi-time-
programmable (MTP) memory, storing device
descriptors and CBUS I/O configuration.
True 3.3V CMOS drive output and TTL input;
operates down to 1V8 with external pull-ups.
Tolerant of 5V inputs.
Fully integrated clock generation with no
external crystal required plus optional clock
output selection enabling a glue-less interface
to external MCU or FPGA.
Configurable I/O pin output drive strength; 4
mA(min) and 16 mA(max)
Integrated power-on-reset circuit.
Data transfer rates to 1MByte/s.
Fully integrated AVCC supply filtering - no
external filtering required.
512 byte receive buffer and 512 byte transmit
buffer utilising buffer smoothing technology to
allow for high data throughput.
+ 5V Single Supply Operation.
Internal 3V3/1V8 LDO regulators
FTDI’s royalty-free Virtual Com Port (VCP) and
Direct
requirement for USB driver development in
most cases.
(D2XX)
drivers
eliminate
the
Low operating and USB suspend current; 8mA
(active-typ) and 125uA (suspend-typ).
Low USB bandwidth consumption.
UHCI/OHCI/EHCI host controller compatible.
USB 2.0 Full Speed capable.
Configurable CBUS I/O pin.
Extended operating temperature range; -40 to
85⁰C.
Available in compact Pb-free 20 Pin SSOP and
QFN packages (both RoHS compliant).
Neither the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced
in any material or electronic form without the prior written consent of the copyright holder. This product and its documentation are
supplied on an as-is basis and no warranty as to their suitability for any particular purpose is either made or implied. Future Technology
Devices International Ltd will not accept any claim for damages howsoever arising as a result of use or failure of this product. Your
statutory rights are not affected. This product or any variant of it is not intended for use in any medical appliance, device or system in
which the failure of the product might reasonably be expected to result in personal injury. This document provides preliminary
information that may be subject to change without notice. No freedom to use patents or other intellectual property rights is implied by
the publication of this document. Future Technology Devices International Ltd, Unit 1, 2 Seaward Place, Centurion Business Park, Glasgow
G41 1HH United Kingdom. Scotland Registered Company Number: SC136640
Copyright © 2013 Future Technology Devices International Limited
1