March 2011
FL7930
Single-Stage Flyback and Boundary-Mode PFC
Controller for Lighting
Features
Description
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Additional PFC-Ready Function (FL7930C Only)
The FL7930 is an active Power Factor Correction (PFC)
controller for low-to high-power lumens applications that
operate in Critical Conduction Mode (CRM). It uses a
voltage-mode PWM that compares an internal ramp
signal with the error amplifier output to generate a
MOSFET turn-off signal. Because the voltage-mode
CRM PFC controller does not need rectified AC line
voltage information, it saves the power loss of an input
voltage sensing network necessary for a current-mode
CRM PFC controller.
Input-Voltage-Absent-Detection Circuit
Maximum Switching Frequency Limitation
Internal Soft-Start with Overshoot Prevention
Internal Total Harmonic Distortion (THD) Optimizer
Precise Adjustable Output Over-Voltage Protection
Additional OVP Detection Pin (FL7930B Only)
Open-Feedback Protection and Disable Function
Zero-Current Detector
FL7930 provides over-voltage, open-feedback, over-
current, input-voltage-absent detection, and under-
voltage lockout protections. The FL7930 can be
disabled if the INV pin voltage is lower than 0.45V and
the operating current decreases to a very low level.
Using a new variable on-time control method, THD is
lower than the conventional CRM boost PFC ICs.
150µs Internal Startup Timer
MOSFET Over-Current Protection (OCP)
Under-Voltage Lockout with 3.5V Hysteresis
Low Startup and Operating Current
The FL3930B provides an additional OVP pin that can
be used to shut down the boost power stage when
output voltage exceeds OVP level due to damaged
resistors connected at the INV pin. The FL7930C
provides a PFC-ready pin can be used to trigger other
power stages when PFC output voltage reaches the
proper level (with hysteresis).
Totem-Pole Output with High State Clamp
+500/-800mA Peak Gate Drive Current
8-Pin Small Outline Package (SOP)
Applications
.
.
.
.
Ballast
General LED Lighting
Industrial, Commercial, and Residential Fixtures
Outdoor Lighting: Street, Roadway, Parking,
Construction and Ornamental LED Lighting Fixtures
Ordering Information
Operating
Temperature Range
Packing
Part Number
Top Mark
Package
Method
FL7930BM
FL7930BMX
FL7930CM
FL7930CMX
Rail
FL7930B
Tape & Reel
-40 to +125°C
8-Lead Small Outline Package (SOP)
Rail
FL7930C
Tape & Reel
© 2011 Fairchild Semiconductor Corporation
FL7930 • Rev. 1.0.0
www.fairchildsemi.com