MODEL: F2AP
Super-mini Signal Conditioners F2 Series
[2] OUTPUT
1: Open collector (max. 1 kHz)
2: 5 V pulse (max. 1 kHz)
DC/FREQUENCY CONVERTER
Functions & Features
• Providing a pulse rate output in proportion to DC input
signal
POWER INPUT
DC Power
• High-density mounting
R: 24 V DC
Typical Applications
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
• Totalizing applications in combination with a counter
[3] OPTIONS
blank: none
22.5 (.89)
/Q: With options (specify the specification)
SPECIFICATIONS OF OPTION: Q
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
75
(2.95)
/C02: Polyurethane coating
107
(4.21)
mm (inch)
GENERAL SPECIFICATIONS
Construction: Stand-alone; terminal access at the front
Connection: Euro type connector terminal
MODEL: F2AP–[1][2]–R[3]
(applicable wire size: 0.2 to 2.5 mm , stripped length 7 mm)
2
Housing material: Flame-resistant resin (black)
Isolation: Input to output to power
ORDERING INFORMATION
• Code number: F2AP-[1][2]-R[3]
Specify a code from below for each [1] through [3].
(e.g. F2AP-61-R/Q)
Zero adjustment: 0 – 5 % (front)
Span adjustment: 95 to 105 % (front)
• Special input range (For codes Z & 0)
• Output frequency range (e.g. 0 – 500 Hz)
• Specify the specification for option code /Q
(e.g. /C01)
INPUT SPECIFICATIONS
■ DC Current: Input resistor incorporated
Specify input resistance value for code Z.
(R ≤ 0.5 W ÷ [F.S. Current]
■ DC Voltage: 0 – 30 V DC
Minimum span: 1 V
2)
[1] INPUT
Current
Input resistance: ≥ 1 MΩ
A: 4 – 20 mA DC (Input resistance 250 Ω)
D: 0 – 20 mA DC (Input resistance 50 Ω)
G: 0 – 1 mA DC (Input resistance 1000 Ω)
H: 10 – 50 mA DC (Input resistance 100 Ω)
Z: Specify current (See INPUT SPECIFICATIONS)
( 0 % input must be 0 mA.)
OUTPUT SPECIFICATIONS
■ Open Collector: 30 V DC @100 mA (resistive load)
Frequency range: 0 – 10 pulses/hour through 1 kHz
Saturation voltage: 0.6 V DC
■ 5 V Pulse
Voltage
Frequency range: 0 – 10 pulses/hour through 1 kHz
Hi level: 3.0 – 5.5 V
3: 0 – 1 V DC (Input resistance 1 MΩ min.)
4: 0 – 10 V DC (Input resistance 1 MΩ min.)
5: 0 – 5 V DC (Input resistance 1 MΩ min.)
6: 1 – 5 V DC (Input resistance 1 MΩ min.)
0: Specify voltage (See INPUT SPECIFICATIONS)
( 0 % input must be 0 V.)
Lo level: ≤ 0.5 V
Load resistance: 250 Ω min.
F2AP SPECIFICATIONS
ES-5436 Rev.6 Page 1/3
http://www.m-system.co.jp/