ETA6005
2.5A / 4.35V, 3MHz Switching Charger with Dynamic Power Path Management
DESCRIPTION
ETA6005 is a switching Li-Ion battery charger with dynamic power-path control and input current limiting.
When a battery is connected, depending on the battery voltage, the DC-DC switching regulator either pre-conditions, fast-charges the battery
or just regulates a system voltage (VSYS) to a preset voltage. It does not require an external sense resistor for current sensing. The fast-
charging current is determined by programming ISET1 or ISET2 pin, depending on the state of the USB_DET. If USB_DET is high, indicating n
valid USB inputis present, the fastcharge currentis setbyISET2; otherwise, itis setbyISET1. When the battery voltage reaches the termination
voltage i.e. 4.35V, the charging path disconnects SYS to BATT. The ETA6005 also includes a dynamic power path when the SYS load current
exceeds current limit of the DCDC regulator internally set, the SYS voltage falls below VBATT, ETA6005 turns on the power-path to supplement
the system load through the battery.
FEATURES
APPLICATIONS
Switching Charger with Power Path Management
Up to 95% DC-DC Efficiency
50mΩ Power Path MOSFET
Up to 2.5A Max charging current
4.35V charging termination voltage
Instant on with a dead Battery or no Battery
No battery detection
No External Sense resistor
Programmable USB and AC IN Charging Current
Tablet, MID
Smart Phone
Power Bank
ORDERING INFORMATION
PART
ETA6005Q3Q-T
PACKAGE PIN TOP MARK
QFN3X3-16
ETA+42
TYPICAL APPLICATION
IN
5V INPUT
10uF
SW
ENB
USB_DET
PGND
2.2uH
SYS
2.2K
SYS
22uF
BATT
SYSTEM
LOAD
ISET1
500Ω
ISET2
1uF
2KΩ
NTC
2A Switching Charger with Dynamic Power Path
www.ETAsolution.com
Outperform with Efficiency
1