NOT RECOMMENDED FOR NEW DESIGNS
RECOMMENDED REPLACEMENT PART
EL5171
DATASHEET
EL2141
150MHz Differential Twisted Pair Driver
FN7048
Rev 1.00
February 11, 2005
The EL2141 is a very high bandwidth amplifier whose output
is in differential form, and is thus primarily targeted for appli-
cations such as driving twisted pair lines, or any application
where common mode injection is likely to occur. The input
signal can be in either single-ended or differential form, but
the output is always in differential form.
Features
• Fully differential inputs, outputs, and feedback
• Differential input range ±2.3V
• 150MHz 3dB bandwidth
• 800V/s slew rate
On the EL2141, two feedback inputs provide the user with
the ability to set the device gain, (stable at minimum gain of
two).
• -55dB distortion at 3MHz
• -75dB distortion at 100kHz
The output common mode level is set by the reference pin
(V
), which has a -3dB bandwidth of over 100MHz. Gen-
• ±5V supplies or +6V single supply
• 50mA minimum output current
• Output swing (200 load) to within 1.5V of supplies
REF
erally, this pin is grounded, but it can be tied to any voltage
reference.
The transmission of ADSL/HDSL signals requires very low
distortion amplification, so this amplifier was designed with
this as a primary goal. The actual signal distortion levels
depend upon input and output signal amplitude, as well as
the output load impedance. (See distortion data inside.)
(14V
differential)
PKPK
• Low power-11mA typical supply current
• Pb-free available (RoHS compliant)
Both outputs (V ) are short circuit protected to
withstand temporary overload condition.
, V
Applications
OUT OUTB
• Twisted pair driver
Ordering Information
• Differential line driver
PART
NUMBER
TAPE &
REEL
• VGA over twisted pair
PACKAGE
8-pin SOIC
8-pin SOIC
8-pin SOIC
PKG. DWG. #
MDP0027
MDP0027
MDP0027
MDP0027
• ADSL/HDSL driver
EL2141CS
-
7”
13”
-
• Single ended to differential amplification
• Transmission of analog signals in a noisy environment
EL2141CS-T7
EL2141CS-T13
EL2141CSZ
(See Note)
8-pin SOIC
(Pb-free)
Pinout
EL2141
(8-PIN SOIC)
TOP VIEW
EL2141CSZ-T7
(See Note)
8-pin SOIC
(Pb-free)
7”
MDP0027
MDP0027
EL2141CSZ-
T13 (See Note)
8-pin SOIC
(Pb-free)
13”
NOTE: Intersil Pb-free products employ special Pb-free material sets;
molding compounds/die attach materials and 100% matte tin plate
termination finish, which are RoHS compliant and compatible with
both SnPb and Pb-free soldering operations. Intersil Pb-free products
are MSL classified at Pb-free peak reflow temperatures that meet or
exceed the Pb-free requirements of IPC/JEDEC J STD-020.
FN7048 Rev 1.00
February 11, 2005
Page 1 of 6