Tantalum Solid Electrolytic Capacitors/TES
Surface Mount Type
Series: TES
Japan
China
Low profile
■ Features
Height: H=1.2mm max.
■ Specifications
Category temp. range
Rated W.V. Range
Nominal Cap. Range
-55 to 125°C
4 to 16 V .DC
0.47 to 15 µ F
Capacitance Tolerance
DC Leakage Current
±20 % (120Hz/20°C)
I < 0.01CV or 0.5 (µA) after 2 minutes application of rated working voltage at 20°C (Whichever is greater)
Please see the attached standard products list
tanδ
Resistance to Soldering Heat
The capacitor shall withstand dipping into solder for 5±1 seconds at 260±5°C
After 500 hours exposure at 40 °C and 90 to 95 % R.H. without load, the capacitor shall meet
the following limits.
Ta
.
TES
Moisture Resistance
Endurance
Capacitance change ±10% of initial measured value
tanδ.
< initial specified value, miniatured size : < 150% of initial specified value.
DC leakage current < initial specified value
After 2000 hours application of rated DC working voltage at 85°C or derated voltage at
125°C, the capacitor shall meet the following limits.
±10% of initial measured value
< initial specified value
Capacitance change
tanδ.
DC leakage current
< 125 % of initial specified value
■ Marking
■ Dimensions in mm (not to scale)
● Size Z
(-)
(+)
Polarity bar (+ side)
L
P
P
w1
Cap. code
W.V.code
W.V. code
4
G
6.3 10 16
W.V. (V)
code
J
A
C
Capacitance code
EIA code
2012
L±0.2 W1±0.2 W2±0.1 H max.
P
Sizecode
Z
Capacitance(µF)
0.47 0.68
1
1.5 2.2 3.3 4.7 6.8 10 15
2.0
0.9
1.2 0.5±0.2
1.25
1st code
S
W
A
E
J
N
S
W
A
E
(Ex.) JE : 6.3V 1.5µF
■ Case size
W.V.(V.DC)
Cap(µF)
0.47 (474)
0.68 (684)
1.0 (105)
1.5 (155)
2.2 (225)
3.3 (335)
4.7 (475)
6.8 (685)
10 (106)
15 (156)
4(0G)
6.3(0J)
10(1A)
16(1C)
Standard
Miniature
Miniature
Standard Miniature
Standard
Miniature
Standard
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Note :1. ( )indicates W.V. and capacitance code.
2. When selecting W.V. refer to page 20.
3. We recommend current sizes shown in the above table for new design, but conventional case size is available on request.
4. Other rating upon request (voltage, capacitance, tolerance)
Rev.02/04
Design, Specifications are subject to change without notice. Ask factory for technical specifications before purchase and/or use.
Whenever a doubt about safety arises from this product, please inform us immediately for technical consulation without fail.
EE31