DTB-R232
230W Redundant Power Supply
0.63
1.3
6.0
0.8
0.7
7.0
7.2
Features
*Input Voltage: 90~130VAC or 180~260VAC
*Input Frequency: 47~63Hz
*Inrush Current: Does not exceed 30A at 115VAC input or
60A AC input, at cold start 25oC
*Load Range: When all outputs are in 60% rated load
condition, the +5V output is set between 4.98~5.02V while
all other outputs are within the specified voltage accuracy
range
6.0
1.3
*Ripple And Noise: Peak to peak ripple and noise for +5V,
output is < 50mV, and < 100mV for +12V, -12V, -5V
outputs at rated load, 115/230VAC
*Line Regulation: < +/-1% for each output at rated load
and +/-10% of 115VAC or 230VAC input voltage change
*Load Regulation: The output voltage load regulation is
less than the value on the table when subjected to +/-40%
change on each output load from 60% rated load, and
while all other outputs are at 60% rated load
*Hold Up Time: > 16ms at 115VAC input and rated load
measured from the last AC line charging pulse to the point
when +5V drops to +4.75V
*Output Power: The total DC continuous power is whthin
o
230W at < 30 C ambient temperature
*Power Good Signal: When turned on, the signal goes
high 100~500ms after all output DC voltages are within
regulation limits
0.61
7.38
Safety Standards
*Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950
*EMI: FCC class B / EN55022B
*EMS: Level 3 of IEC-801, 802, 803, 804
Output Min. Rated Max.
Tolerance
*Power Redundancy: This power supply has power
redundant capability
*Efficiency: > 70% at rated load
Voltage Load Load
Load
25A
12A
1A
+5V 1A
+12V 0.1A
20A
10A
0.5A
0.5A
+/-0.1V
+/-0.72V
+/-0.6V
+/-0.25V
-12V
-5V
0A
0A
*Altitude: 10,000 feet
1A
*Protection: Built-in over voltage protection circuit shuts
down the outputs to prevent damage. Trip point of crowbar
circuit is between 5.7~7V; latch off mode against short
circuit or over load conditions AC line ON/OFF cycle
recovers unit from fault conditions
*Temperature: 0~+40oC (operating); -40~+75oC
(storage)
*Humidity: 5~95%; non-condensing at 40oC (operating)
*Connectors:
AC: One AC input socket
DC: O1 DIN 41612 C96
*Dimensions: 14.0 x 15.0 x 8.62 cm +/-5mm tolerance
*MTBF: 235,743 hrs.
www.boser.com.tw