DS3695A, DS3695AT, DS3696A
www.ti.com
SNLS353C –FEBRUARY 1996–REVISED APRIL 2013
DS3695A/DS3695AT/DS3696A Multipoint RS485/RS422 Transceivers
Check for Samples: DS3695A, DS3695AT, DS3696A
1
FEATURES
DESCRIPTION
The DS3695A and DS3696A are high speed
2
•
Meets EIA Standard RS485 for Multipoint Bus
Transmission and is Compatible with RS-422
differential TRI-STATE bus/line transceivers designed
to meet the requirements of EIA standard RS485 with
extended common mode range (+12V to −7V), for
multipoint data transmission. In addition they are
compatible with requirements of RS-422.
•
•
•
10 Ns Driver Propagation Delays (Typical)
Single +5V Supply
−7V to +12V Bus Common Mode Range
Permits ±7V Ground Difference between
Devices on the Bus
The driver and receiver outputs feature TRI-STATE
capability. The driver outputs remain in over the
entire common mode range of +12V to −7V. Bus
faults that cause excessive power dissipation within
the device trigger a thermal shutdown circuit, which
forces the driver outputs into the high impedance
state. The DS3696A provides an output pin (TS)
which reports the thermal shutdown of the device. TS
is an “open collector” pin with an internal 10 kΩ pull-
up resistor. This allows the TS outputs of several
devices to be wire OR-ed.
•
•
Thermal Shutdown Protection
High Impedance to Bus with Driver in TRI-
STATE or with Power Off, over the Entire
Common Mode Range Allows the Unused
Devices on the Bus to be Powered Down
•
Combined Impedance of a Driver Output and
Receiver Input is less than One RS485 Unit
Load, Allowing up to 32 Transceivers on the
Bus
Both AC and DC specifications are guaranteed over
the 0°C to 70°C temperature and 4.75V to 5.25V
supply voltage range.
•
•
70 mV Typical Receiver Hysteresis
Available in SOIC Packaging
Connection and Logic Diagrams
Figure 1. Molded Package, Small Outline (D0008A)
Top View
Figure 2. Top View
(See Package Number D0008A)
TS was LF (Line Fault) on previous datasheets, TS goes low upon thermal shutdown.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
All trademarks are the property of their respective owners.
2
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 1996–2013, Texas Instruments Incorporated