DS2505
16-kbit Add-Only Memory
www.dalsemi.com
FEATURES
PIN ASSIGNMENT
ꢀ 16384 bits Electrically Programmable Read
Only Memory (EPROM) communicates with
the economy of one signal plus ground
ꢀ Unique, factory-lasered and tested 64-bit
registration number (8-bit family code +
48-bit serial number + 8-bit CRC tester)
assures absolute traceability because no two
parts are alike
TSOC PACKAGE
TO-92
1
2
3
6
5
4
GND
DATA
NC
NC
NC
NC
DALLAS
DS2505
Top View
3.7 X 4.0 X 1.5 mm
ꢀ Built-in
multidrop
controller
ensures
Net
compatibility with other 1-Wire
products
Side View
See Mech.
ꢀ EPROM partitioned into sixty-four 256-bit
pages for randomly accessing packetized data
records
Drawing Section
ꢀ Each memory page can be permanently write-
protected to prevent tampering
ꢀ Device is an “add only” memory where
additional data can be programmed into
EPROM without disturbing existing data
ꢀ Architecture allows software to patch data by
superseding an old page in favor of a newly
programmed page
1 2 3
Bottom View
See Mech.
Drawings Section
ꢀ Reduces control, address, data, power, and
programming signals to a single data pin
ꢀ Directly connects to a single port pin of a
microprocessor and communicates at up to
16.3 kbits per second
ORDERING INFORMATION
DS2505
TO-92 Package
DS2505P
6-pin TSOC Package
DS2505/T&R Tape & Reel version of DS2505
DS2505P/T&R Tape & Reel version of DS2505P
ꢀ 8-bit family code specifies DS2505
communications requirements to reader
ꢀ Presence detector acknowledges when the
reader first applies voltage
ꢀ Low cost TO-92 or 6-pin TSOC surface
mount package
ꢀ Reads over a wide voltage range of 2.8V to
6.0V from -40°C to +85°C; programs at
11.5V to 12.0V from -40°C to +50°C
1 of 24
032201