DS2408
1-Wire 8-Channel Addressable Switch
www.maxim-ic.com
FEATURES
PIN CONFIGURATION
CꢀEight Channels of Programmable I/O with
Open-Drain Outputs
N.C.
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
N.C.
N.C.
P1
P0
CꢀOn-Resistance of PIO Pulldown Transistor
100ꢀ (max); Off-Resistance 10Mꢀ (typ)
CꢀIndividual Activity Latches Capture
Asynchronous State Changes at PIO Inputs
for Interrogation by the Bus Master
CꢀData-Strobe Output to Synchronize PIO
Logic States to External Read/Write Circuitry
CꢀBuilt-in Multidrop Controller Ensures
Compatibility with Other Dallas
VCC
I/O
P2
GND
N.C.
P7
P3
P4
RSTZ
P5
P6
150-mil SO
Semiconductor 1-Wire® Net Products
CꢀSupports 1-Wire Conditional Search
Command with Response Controlled by
Programmable PIO Conditions
ORDERING INFORMATION
TEMP
PART
PACKAGE
CꢀUnique Factory-Lasered 64-Bit Registration
Number Ensures Error-Free Device Selection
and Absolute Part Identity
RANGE
DS2408S
DS2408S
/T&R
16-Pin SO, 150 mil
Tape-and-Reel of
DS2408S
-40LC to +85LC
-40LC to +85LC
CꢀCommunicates to Host with a Single Digital
Signal at 15.3kbps or 100kbps using 1-Wire
Protocol
CꢀOperating Range: 2.8V to 5.25V, -40°C to
+85°C
DESCRIPTION
The DS2408 is an 8-channel, programmable I/O 1-Wire chip. PIO outputs are configured as open-drain
and provide an on resistance of 100ꢀ max. A robust PIO channel-access communication protocol ensures
that PIO output-setting changes occur error-free. A data-valid strobe output can be used to latch PIO logic
states into external circuitry such as a D/A converter (DAC) or microcontroller data bus.
DS2408 operation is controlled over the single-conductor 1-Wire bus. Device communication follows the
standard Dallas Semiconductor 1-Wire protocol. Each DS2408 has its own unalterable and unique 64-bit
ROM registration number that is factory lasered into the chip. The registration number guarantees unique
identification and is used to address the device in a multidrop 1-Wire net environment. Multiple DS2408
devices can reside on a common 1-Wire bus and can operate independently of each other. The DS2408
also supports 1-Wire conditional search capability based on PIO conditions or power-on-reset activity;
the conditions to cause participation in the conditional search are programmable. The DS2408 has an
optional VCC supply connection. When an external supply is absent, device power is supplied parasitically
from the 1-Wire bus. When an external supply is present, PIO states are maintained in the absence of the
1-Wire bus power source. The RSTZ signal is configurable to serve as either a hard-wired reset for the
PIO output or as a strobe for external circuitry to indicate that a PIO write or PIO read has completed.
1-Wire is a registered trademark of Dallas Semiconductor.
1 of 36
061604