DM100E Series
UltraMiniature, 1W SIP
Single & Dual Output
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Key Features:
• 1W Output Power
Conditions
Min.
Typ.
5.0
Max.
5.5
Units
5 VDC Input
4.5
• UltraMiniature SIP Case
• Low 0.3 Inch Profile
• Single & Dual Outputs
Input Voltage Range
VDC
12 VDC Input 10.8
Internal Capacitor
12.0
13.2
Input Filter
• 1,000 VDC Isolation
• >3.5 MHour MTBF
• 12 Standard Models
• LOWEST COST!!
Reverse Polarity Input Current
Output
0.3
A
Parameter
Conditions
Min.
Typ.
1.0
0.1
1.2
Max.
3.0
Units
%
Output Voltage Accuracy
Output Voltage Balance
Line Regulation
Dual Output , Balanced Loads
For Vin Change of 1%
1.0
%
%
Load Regulation (Note 1)
Ripple & Noise (20 MHz) (Note 2)
Output Power Protection
Temperature Coefficient
Output Short Circuit
General
See Model Selection Guide
50
75
mV P - P
%
120
0.02
0.03
%/ºC
Momentary (1.0 Sec.)
RoHS Compliant
Parameter
Conditions
Conditions
Min.
60 Seconds 1,000
500 VDC 1,000
100 kHz, 1V
Typ.
Max.
Units
VDC
MΩ
pF
Isolation Voltage
Isolation Resistance
Isolation Capacitance
Switching Frequency
Environmental
Parameter
60
100
kHz
Min.
Typ.
Max.
+85
Units
ºC
Operating Temperature Range
Operating Temperature Range
Storage Temperature Range
Cooling
Ambient
Case
-40
-40
-55
+25
+90
ºC
+125
ºC
Free Air Convection
RH, Non-condensing
Humidity
95
%
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Physical
Case Size
0.65 x 0.23 x 0.30 Inches (16.5 x 5.9 x 7.5 mm)
Non-Conductive Black Plastic (UL94-V0)
0.07 Oz (2.1g)
Case Material
Weight
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
Reliability Specifications
Parameter
Conditions
Min.
Typ.
Typ.
Max.
Units
W: www.micropowerdirect.com MTBF
MIL HDBK 217F, 25ºC, Gnd Benign
3.5
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min.
Max.
9.0
Units
5 VDC Input -0.7
12 VDC Input -0.7
Input Voltage Surge (1 Sec)
VDC
18.0
300
450
Lead Temperature
1.5 mm From Case For 10 Sec
All Models
ºC
Internal Power Dissipation
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.