5秒后页面跳转
DIO5060A PDF预览

DIO5060A

更新时间: 2024-04-09 19:00:03
品牌 Logo 应用领域
帝奥微 - DIOO /
页数 文件大小 规格书
19页 1640K
描述
The DIO5060A is integrated Li-Ion linear chargers and system power path management devices that ar

DIO5060A 数据手册

 浏览型号DIO5060A的Datasheet PDF文件第2页浏览型号DIO5060A的Datasheet PDF文件第3页浏览型号DIO5060A的Datasheet PDF文件第4页浏览型号DIO5060A的Datasheet PDF文件第5页浏览型号DIO5060A的Datasheet PDF文件第6页浏览型号DIO5060A的Datasheet PDF文件第7页 
Rev 1.8  
DIO5060A/B  
Standalone 1-Cell 600 mA Linear Battery Charger with  
Power Path, 1 mA Termination, and Battery Leakage  
below 1 uA  
Features  
Descriptions  
Input overvoltage protection with 6.5 V  
The DIO5060A/B series are integrated Li-Ion linear  
chargers and system power path management  
devices that are targeted at space-limited  
portable applications. The charger accepts an  
input voltage of up to 25 V but is disabled when  
the input voltage exceeds the OVP threshold,  
typically 6.5 V, to prevent excessive power  
Charge status indicator  
Charge current accuracy: 10%  
Charge voltage accuracy: 0.7%  
Battery supplement mode  
Supports from 10 mA up to 600 mA charge  
current with current monitoring output (ISET)  
Programmable pre-charge current by resistor  
Programmable ITERM charge current by  
resistor  
dissipation. The 25 V rating eliminates the  
overvoltage protection circuit required in a low  
input-voltage charger. The input voltage range  
with input overvoltage protection supports  
unregulated adapters.  
Pre-charge for 30 minutes safety timing  
Fast-charge for 6 hours safety timing  
Under 1 uA leakage off the battery, when no  
input power attached  
The DIO5060A/B features dynamic power path  
management (DPPM) that powers the system  
while simultaneously and independently charging  
the battery. The DPPM circuit reduces the charge  
current when the input current limit causes the  
system output to fall to the DPPM threshold; thus,  
supplying the system load at all times when  
monitoring the charge current separately. This  
feature reduces the number of charge and  
discharge cycles on the battery, allows for proper  
charge termination, and enables the system to  
run with a defective or absent battery pack.  
SEL1 and SEL2 pins control 0.5C, 1C, 2C of  
fast-charge (DIO5060A)  
50 μA standby current into IN pin after full  
charge  
Applications  
Smart phones  
Portable media players  
Portable navigation devices  
Low-power handheld device  
www.dioo.com  
© 2023 DIOO MICROCIRCUITS CO., LTD  
DIO5060A/B• Rev. 1.8  
- 1 -  

与DIO5060A相关器件

型号 品牌 获取价格 描述 数据表
DIO5060B DIOO

获取价格

The DIO5060B series are integrated Li-Ion linear chargers and system power path management
DIO5081 DIOO

获取价格

DIO5081 is highly integrated lithium ion and lithium polymer linear chargers, suitable for
DIO5090C DIOO

获取价格

DIO5090C series devices are highly integrated lithium ion and lithium polymer linear charg
DIO5090X DIOO

获取价格

DIO5090X is highly integrated lithium ion and lithium polymer linear chargers, suitable fo
DIO5100 DIOO

获取价格

The DIO5100 is a single Phase 12V MOSFET gate drivers optimized to drive the gates of both
DIO5105 DIOO

获取价格

The DIO5105 is a single Phase 40V MOSFET gate drivers optimized to drive the gates of both
DIO5110 DIOO

获取价格

The DIO5110 is a single Phase 12V MOSFET gate drivers optimized to drive the gates of both
DIO5151 DIOO

获取价格

The DIO5151 is a current-regulated charge pump, ideal for powering high brightness LEDs fo
DIO5151B DIOO

获取价格

The DIO5151B is a current-regulated charge pump ideal for powering high brightness LEDs f
DIO5322 DIOO

获取价格

DIO5322 is a serial white LED driver, featuring architecture of 90% high-efficiency curren