DGP30 SERIES
SINGLE OUTPUT
DESCRIPTION
FEATURES
The single output DGP30 Series is designed to accept an extended
2:1 input voltage range for use in industrial and telecom
applications. The output of the converter is electrically isolated,
thereby allowing the output to be configured as a positive or
negative output voltage. For additional system utility output Trim
and Remote ON/OFF are featured. Overcurrent protection,
overtemperature protection, and output overvoltage transient
protection allow safe, reliable operation.
• Remote ON/OFF and TRIM
• Low OFF Current
• Overcurrent and Overtemperature Protection
• Efficiencies to 86%
• Transient Output Overvoltage Protection
• 1544V Isolation
• Five-Side Shielded Case
• Extended Range Input (2:1)
BOTTOM VIEW
SIDE VIEW
2.02
(51.31)
0.040 (1.02) DIA
6 PLACES
0.700
5
6
7
(17.78)
0.600
1
2
(15.24)
1.62
(41.15)
0.400
(10.16)
0.300
(7.62)
3
0.000
0.100
(2.54)
0.31
(7.9)
Mechanical tolerances unless otherwise noted:
X.XX dimensions: ±±.±0± inches
X.XXX dimensions: ±±.±±ꢀ inches
NOTES
(1) All parameters measured at Tc = 0ꢀ°C, nominal input voltage and full rated load unless otherwise noted.
Refer to the Technical Reference Section for the definition of terms, measurement circuits and other
information.
(0) ON/OFF pin is referenced to pin 0, -Input. See DGP3± Series Application Notes for the specific
requirements of this feature.
(3) The Case is electrically connected to Pin 1, +Input.
(4) Full output trim range may not be available at minimum input voltage and full load. Full trim is
guaranteed from minimum input voltage, plus ꢀ%, and full load.
(ꢀ) The case thermal impedance is specified as the case temperature rise over ambient per package watt
dissipated.
Rev. 04/2000
1