Device
Engineering
Incorporated
DEI1090
LED Driver with Square-Law
Dimming Control
6031 South Maple Ave.
Tempe, AZ 85283
Phone: (480) 303-0822
Fax: (480) 303-0824
E-mail: admin@deiaz.com
FEATURES
·
·
·
·
·
·
·
Emulates incandescent lamp ‘Square Law’ luminance curve.
LED dimming controlled by Pulse Width Modulation ranging from 50HZ to 200HZ.
Maximum LED current adjustable from 10mA to 20mA.
200:1 Dimming Range at 50Hz. 40:1 Dimming Range at 200Hz
Drives 8 LED outputs with matched current drive.
Drivers can be cascaded to synchronously drive additional LEDs.
Package Options
o
o
Plastic 16 lead SOIC
20L QFN 5 X 5
APPLICATIONS
·
·
·
LED replacement for dimmable incandescent lamps.
Avionics instrument and panel lighting.
Balanced display and keyboard backlighting.
GENERAL DESCRIPTION
DEI1090 device is a 16 pin bipolar integrated circuit designed to drive eight LEDs and provide Pulse Width Modulated (PWM)
dimming control according to the luminance curve of incandescent lamps. All eight LEDx pins are driven with an average current
proportional to the square of the input dimming voltage to control the LED brightness. Drivers can be cascaded to synchronously
drive additional LED groups. The dimming control input may be a DC or AC voltage.
Table 1 – SOIC Terminal Description
PIN
1
NAME
VDD
DESCRIPTION
POWER INPUT: +4.5 to +16.5 VDC
ANALOG INPUT: 0 to 2.5V AC or DC analog input for
brightness control.
2
3
VIN
1
16
VDD
VIN
ENABLE
PWM
LED8
LED7
LED6
LED5
ISET
ANALOG IO: Optional external filter resistor and capacitor
used when 400HZ AC control signals are supported. This pin
must be connected to ground through a resistor even in DC
FILT
FILT
LED1
LED2
LED3
FSET
GND
LED DRIVE OUTPUT: LED cathode connection. LED
4-6,9,
11-14
LED1-8
FSET
average current is proportional to the square of VIN.
ANALOG INPUT: External capacitor input to set PWM
frequency.
7
POWER INPUT: Ground.
8
GND
ISET
LED4
ANALOG INPUT: External resistor input to set LED current.
10
ANALOG OUTPUT: PWM output drives multiple 1090 slave
devices for synchronous operation.
15
16
PWM
LOGIC INPUT: HIGH enables operation. LOW sets all LED
outputs OFF and sets standby state.
ENABLE
© 2019 Device Engineering Incorporated
Page 1 of 13
DS-MW-01090 Rev J
10/30/2019