DA9130
High-Performance, 10 A, Dual-Phase DC-DC
Converter for Mobile and Portable Applications
General Description
DA9130 is a power management IC (PMIC) suitable for supplying CPUs, GPUs, DDR memory rails
in single in-line pin package (SIPP) modules, mobile, portable and consumer applications.
DA9130 operates as a single-channel dual-phase buck converter, each phase requiring a small
external 0.22 µH inductor. It is capable of delivering up to 10 A output current at a 0.3 V to 1.9 V
output voltage range. The 2.8 V to 5.5 V input voltage range is suitable for a wide variety of low-
voltage systems.
With remote sensing, the DA9130 guarantees the highest accuracy and supports multiple PCB
routing scenarios without loss of performance.
The pass devices are fully integrated, so no external FETs or Schottky diodes are needed.
A programmable soft start-up can be enabled, which limits the inrush current from the input node and
secures a slope-controlled rail activation.
The dynamic voltage control (DVC) supports adaptive adjustment of the supply voltage dependent on
the processor load, via either a direct register write using the communication interface (I2C-
compatible) or with a programmable input pin.
A configurable GPI allows multiple I2C address selection for multiple instances of DA9130 in the
same application.
DA9130 has integrated over-temperature and over-current protection for increased system reliability,
without the need for external sensing components.
Key Features
■
■
■
■
■
■
■
■
■
2.8 V to 5.5 V input voltage
0.3 V to 1.9 V output voltage
4 MHz nominal switching frequency
±1 % accuracy (static)
■
Key safety features
□
Output under-voltage and over-voltage
protection
□
□
Input under-voltage protection
2-step over-temperature protection
±5 % accuracy (dynamic)
I2C-compatible interface (FM+)
Programmable GPIOs
■
■
-40 °C to +105 ºC ambient temperature
range
AEC-Q100 Grade 2 qualified version also
available for Automotive applications
(DA9130-A)
Programmable soft-start
Voltage, current, and temperature
supervision
■
24-pin FCQFN package (nom. 3.3 mm x
4.8 mm)
■
-40 °C to +105 ºC ambient temperature
range
□
Wettable flanks
Benefits
■
■
■
High Efficiency buck converters deliver outstanding thermal performance
Fully integrated switching FET’s means no external FETs or Schottky diodes are required
Remote sensing guarantees the highest accuracy and supports multiple PCB routing scenarios
without loss of performance.
■
■
Fully programmable soft-start limits the inrush current from the input to give a slope-controlled
output voltage.
Dynamic voltage control (DVC) enables adaptive adjustment of the device output voltage
depending on the load. This increases efficiency when the downstream circuitry enters low power
or idle mode, resulting in power savings.
Datasheet
Revision 2.0
11-Aug-2021
CFR0011-120-00
1 of 46
© 2021 Dialog Semiconductor