DA9062-A
PMIC for Applications Requiring up to 8.5 A
General Description
DA9062-A is a power management integrated circuit (PMIC) optimized for supplying systems with
single- and dual-core processors, I/O, DDR memory, and peripherals. It targets car navigation,
vehicle infotainment systems, automotive telematics and FPGA based applications.
DA9062-A features four buck converters providing a total current of 8.5 A. High efficiency is achieved
over a wide load range with PFM mode available for low power or sleep modes. All power switches
are integrated; therefore, external Schottky diodes are not required. Furthermore, low-profile
inductors can be used with DA9062-A. Two of the buck converters can be used in a dual-phase
configuration, and one can be used as a DDR VTT supply. The four LDO regulators with
programmable output voltage provide up to 300 mA.
Dynamic voltage control (DVC) allows dynamic control of DA9062-A supply voltages according to the
operating point of the system. It is controlled by writing directly to the registers using the I2C
compatible 2-wire interface or the GPIOs.
DA9062-A features a programmable power sequencer that handles start-up and shutdown
sequences. Power mode transitions can be triggered with software control, GPIOs, or with the on-
key. Several types of on-key presses can be detected to trigger different power mode transitions.
The real-time clock (RTC), with an external 32 kHz crystal oscillator, provides time keeping and alarm
functions. Additionally, the integrated watchdog timer monitors the system.
Five GPIOs are able to perform system functions, including: keypad supervision, application wake
up, and timing-controlled external regulators/power switches or other ICs.
DA9062-A is also available as a consumer and industrial version DA9062.
Key Features
■
■
Input voltage 2.8 V to 5.5 V
■
■
Programmable power mode sequencer
Four buck converters with DVC:
System supply and junction temperature
monitoring
□
□
Buck1: 0.3 V to 1.57 V, 2.5 A
■
Watchdog timer
Buck2: 0.3 V to 1.57 V, 2.5 A
(can be used in dual-phase configuration ■ Five GPIOs
with Buck1)
■
■
■
■
■
Coin cell/super-capacitor charger
□
□
Buck3: 0.8 V to 3.34 V, 2 A
Ultra-low power RTC with alarm
Buck4: 0.53 V to 1.8 V, 1.5 A
(can be used as DDR VTT supply)
32 kHz oscillator with external crystal
-40 °C to +125 °C junction temperature range
■
■
3 MHz switching frequency
(enables low profile inductors)
40-pin QFN 6 mm × 6 mm package, 0.5 mm
pitch (exposed paddle)
Four LDO regulators:
■
Automotive AEC-Q100 Grade 2 (-40 °C to
105 °C)
□
□
LDO1: 0.9 V to 3.6 V, 100 mA
LDO2, LDO3, LDO4: 0.9 V to 3.6 V,
300 mA
Applications
■
■
■
Car navigation systems
In-car infotainment
Telematics
■
■
Single core application processors
FPGAs
Datasheet
Revision 2.6
15-Feb-2022
CFR0011-120-00
1 of 98
© 2022 Renesas Electronics