D100EHISeries
Low Cost, Miniature SIP
1W, Very High Isolation
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Key Features:
• 1W Output Power
• 6,000 VDC Isolation
• 7 Pin SIP Case
• 5V and 12V Inputs
• Single & Dual Outputs
Conditions
Min.
Typ.
5.0
Max.
5.5
Units
5 VDC Input
4.5
Input Voltage Range
VDC
12 VDC Input 10.8
Internal Capacitor
12.0
13.2
Input Filter
Short Circuit Input Power
Output
1,500
mW
• 16 Standard Models
• 3.5 MH MTBF
Parameter
Conditions
Min.
Typ.
2.0
Max.
4.0
3.0
1.2
15
Units
%
Output Voltage Accuracy
Output Voltage Balance
Line Regulation
• LOWEST COST!!
Dual Output , Balanced Loads
For Vin Change of 1%
Iout = 10% to 100%
1.0
%
%/%
%
Load Regulation, 5V Input
Load Regulation, 12V & 24V Input
Ripple & Noise (20 MHz) (Note 1)
Output Power Protection
Temperature Coefficient
Output Short Circuit
General
Iout = 10% to 100%
10
%
250
300
mV P - P
%
120
0.01
0.03
Max.
20
%/ºC
Momentary (1.0 Seconds)
RoHS Compliant
Parameter
Conditions
Min.
60 Seconds 6,000
500 VDC 1,000
100 kHz, 1V
Typ.
Units
VDC
MΩ
pF
Isolation Voltage
Isolation Resistance
Isolation Capacitance
Switching Frequency
5 VDC Input
250
50
kHz
12 VDC Input
Environmental
Parameter
Conditions
Min.
-40
Typ.
Max.
+85
Units
ºC
Operating Temperature Range
Storage Temperature Range
Cooling
Ambient
-55
+125
ºC
Free Air Convection
RH, Non-condensing
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Humidity
95
%
Physical
Case Size
0.77 x 0.38 x 0.50 Inches (19.5 x 9.8 x 12.5 mm)
Non-Conductive Black Plastic (UL94-V0)
0.42 Oz (12g)
Case Material
Weight
T: (781) 344-8226
Reliability Specifications
Parameter
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Conditions
Min.
Typ.
Typ.
Max.
Units
MTBF
MIL HDBK 217F, 25ºC, Gnd Benign
3.5
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min.
Max.
7.5
Units
5 VDC Input -0.7
12 VDC Input -0.7
Input Voltage Surge (1 Sec)
VDC
15.0
300
Lead Temperature
1.5 mm From Case For 10 Sec.
All Models
ºC
Internal Power Dissipation
1,500
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.