CYAT817L/LS
PSoC™ Automotive Multitouch Generation
7L
Datasheet Summary
Note that this is a Summary Datasheet. To access the full version of this datasheet, register in My Infineon
Collaboration Platform (MyICP).
Features
• Automotive Electronics Council (AEC) Q100 qualified
• Single-chip system solution that integrates touch controller with MCU functions
• Target Application
- Entry and mid-level central information display (CID) systems
• 32-bit MCU subsystem
- 48-MHz Arm® Cortex®-M0+ CPU
- 12-bit SAR ADC for system monitoring (voltage, temperature) and other features (such as day/night sensor)
- Four timer counter pulse width modulators (TCPWMs)
- Three serial communication blocks (SCBs) that can be individually configured as SPI/I2C/UART
- Up to 48 KB flash for user-specific system MCU functionality
- Up to 4 KB SRAM for user-specific system MCU functionality
- Up to 29 programmable GPIO pins with interrupt functionality
• Multi-touch capacitive touchscreen controller
- Register-configurable
- Noise-suppression technologies for display and EMI
• Effective 20-V drive for higher signal-to-noise ratio (SNR)[1]
• AutoArmor improves both electromagnetic emissions and immunity
• External display synchronization
- Water rejection and wet-finger tracking using DualSense
- Multi-touch glove with automatic mode switching
• Ten fingers with thin glove (≤ 1-mm thick)
• Two fingers with thick glove (≤ 5-mm thick)
- Large object rejection
- Automatic baseline tracking to environmental changes
- Low-power look-for-touch mode
- Field upgrades via bootloader
- Touchscreen sensor self-test
- Low power CAPSENSE™ wake-up button with power consumption of 50 µA
- Low power wake-on-touchscreen with power consumption of 120 µA
Note
1. Effective voltage when using 17 multi-phase TX and 5-V VCCTX supply.
Datasheet Summary
www.infineon.com
Please read the Important Notice and Warnings at the end of this document
page 1
002-35927 Rev. **
2022-07-26