CY7C1348G
4-Mbit (128K x 36) Pipelined DCD Sync SRAM
Features
Functional Description[1]
• Registered inputs and outputs for pipelined operation
• Optimal for performance (Double-Cycle deselect)
— Depth expansion without wait state
The CY7C1348G SRAM integrates 128K x 36 SRAM cells with
advanced synchronous peripheral circuitry and a two-bit
counter for internal burst operation. All synchronous inputs are
gated by registers controlled by a positive-edge-triggered
Clock Input (CLK). The synchronous inputs include all
addresses, all data inputs, address-pipelining Chip Enable
(CE1), depth-expansion Chip Enables (CE2 and CE3), Burst
• 128K × 36 common I/O architecture
• 3.3V core power supply (VDD
)
• 3.3V/2.5V I/O power supply (VDDQ
)
Control inputs (ADSC, ADSP,
(BW[A:D], and BWE), and Global Write (GW). Asynchronous
inputs include the Output Enable (OE) and the ZZ pin.
ADV), Write Enables
and
• Fast clock-to-output times
— 2.6 ns (for 250-MHz device)
Addresses and chip enables are registered at rising edge of
clock when either Address Strobe Processor (ADSP) or
Address Strobe Controller (ADSC) are active. Subsequent
burst addresses can be internally generated as controlled by
the Advance pin (ADV).
• Provide high-performance 3-1-1-1 access rate
• User-selectable burst counter supporting Intel®
Pentium® interleaved or linear burst sequences
• Separate processor and controller address strobes
• Synchronous self-timed writes
Address, data inputs, and write controls are registered on-chip
to initiate a self-timed Write cycle.This part supports Byte Write
operations (see Pin Descriptions and Truth Table for further
details). Write cycles can be one to four bytes wide as
controlled by the byte write control inputs. GW active LOW
causes all bytes to be written. This device incorporates an
additional pipelined enable register which delays turning off
the output buffers an additional cycle when a deselect is
executed.This feature allows depth expansion without penal-
izing system performance.
• Asynchronous Output Enable
• Available in lead-free 100-Pin TQFP package
• “ZZ” Sleep Mode option
The CY7C1348G operates from a +3.3V core power supply
while all outputs operate with a +3.3V or a +2.5V supply. All
inputs and outputs are JEDEC-standard JESD8-5-compatible.
Selection Guide
250 MHz
200 MHz
2.8
166 MHz
3.5
133 MHz
4.0
Unit
ns
Maximum Access Time
2.6
325
40
Maximum Operating Current
Maximum CMOS Standby Current
265
240
225
mA
mA
40
40
40
Note:
1. For best-practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
Cypress Semiconductor Corporation
Document #: 38-05608 Rev. *D
•
198 Champion Court
•
San Jose, CA 95134-1709
•
408-943-2600
Revised July 5, 2006