REV COUNT DESCRIPTION OF REVISIONS
BY
PMC
KYG
CHKD DATE
REV COUNT DESCRIPTION OF REVISIONS
Revised
BY
CHKD DATE
LHJ
LHJ
19.09.30
21.08.23
KYI
LHJ
21.12.16
-
-
RE-2-1344 (Released)
Revised
-
1
2
3
Universal Serial Bus Type-C Cable and Connector Specification Release 2.1
Universal Serial Bus Type-C Connectors and Cable Assemblies Compliance Document Revision 2.1b
APPLICABLE STANDARD
1.50A max. for each power pin (i.e. A1, A4, A9, A12, B1, B4, B9, B12)
1.25A max. for VCON(i.e. B5), 0.25A for the other pins
CURRENT
VOLTAGE
RATING
48V AC/DC
-40℃ ~ +105℃ (INCLUDING TEMP. RISE), 95% RH max. (NON-CONDENSING)
-10℃ ~ +60℃ (WITH PACKING), 15% ~ 70% RH
OPERATING CONDITION
STORAGE CONDITION
Para.
1
Test Description
Test Procedure
Test Requirement
QT AT
O O
EIA 364-18
Visual inspection
No physical damage.
Examination of product
Electrical Requirements
EIA 364-23
Measure at 20mV max open circuit
at 100mA max. (DC or 1000Hz)
4-wire measurement is required and
the resistance of PCB termination
shall be deducted from the reading.
Low Level Contact
Resistance
Initial : 40mΩ max
After test : 50mΩ max
2
O
-
EIA 364-20
Dielectric
Withstanding Voltage
Measure per Method B with
unmated condition.
100V AC RMS for 1 minute at sea level.
No disruptive discharge.
3
O
O
-
-
EIA 364-21
500V DC with unmated and mated condition.
100MΩ min.
4
Insulation Resistance
Mechanical Requirements
EIA 364-13
Measure at 12.5mm/minute min.
Initial & After test : 5N ~ 20N
(with virgin plug)
5
6
Insertion force
O
O
-
-
EIA 364-13
Measure at 12.5mm/minute min.
Initial : 8N ~ 20N
After test : 6N ~ 20N (with virgin plug)
Extraction force
EIA 364-09
Mated 10,000 times
Mechanically operated : 500cycles/hr
Mating stroke : 2.75mm
No physical damage.
7
Durability
O
-
Insertion, extraction force shall be measured
at a maximum speed of 12.5mm/min
EIA 364-28
Test Condition VII, Test Letter D
Mated specimens to 3.10 G's RMS
between 20 to 500Hz
No physical damage.
No discontinuity of 1μs of longer duration
when mated connector during test.
8
Random Vibration
O
-
15 minutes in each of 3 mutually
perpendicular planes.
REMARKS
DRAFT
DESIGN
CHECK
APPROVAL
RELEASE
DEPT
23.04.05
ENG
M.C.PAEK M.C.PAEK
H.J.LEE
H.J.LEE
19.09.20
19.09.20
19.09.20
19.09.20
NOTE) QT : QUALIFICATION TEST, AT : ASSURANCE TEST, O : Applicable Test
DWG NO CL NO
PART NO
ELC4-632837-00
CL 6240-0026-0-000
CX90MF-16P
1
HIROSE KOREA.CO.,LTD
PRODUCT SPECIFICATION
3