CHKD
LHJ
CHKD
Rev.
Count
-
Description of rev.
Initial release
BY
Date
Rev.
Count
Description of rev.
BY
Date
22.12.16
KYJ
0
Universal Serial Bus Type-C Cable and Connector Specification Release 2.2
Universal Serial Bus Type-C Connectors and Cable Assemblies Compliance Document Revision 2.1b
Applicable standard
Rating
Voltage 48V AC/DC
1.25A max. for each power pin (i.e., A1, A4, A9, A12, B1, B4, B9, B12)
Current 1.25A max. for Vcon pin (i.e., B5)
0.25A max. for the others.
Operating condition
Storage condition
-40℃~+105℃(Including temp. rise), 95% RH max.(Non-condensing)
-10℃~+60℃(With packing), 15%~70% RH
SPECIFICATIONS
Q
T
A
T
No
CONSTRUCTION
General Examination
TEST ITEM
TEST METHOD
TEST REQUIREMENT
EIA 364-18
No physical damage
1
O
O
Visual inspection
ELECTRICAL CHARACTERISTICS
EIA 364-23
Measure at 20mV max open circuit
at 100mA max. (DC or 1000Hz)
4-wire measurement is required and
the resistance of PCB termination
shall be deducted from the reading.
EIA 364-20
Low level contact
resistance
Initial : 40mΩ max
2
O
-
After test : 50mΩ max
Measure per Method B with
unmated condition.
Dielectric
No disruptive discharge.
3
4
O
O
-
-
Withstanding Voltage
100V AC RMS for 1 minute at sea level.
EIA 364-21
Insulation resistance
100MΩ min.
500V DC with unmated and mated condition.
MECHANICAL CHARACTERISTICS
EIA 364-13
Initial : 5N ~ 20N
Insertion force
Measure at 12.5mm/minute min.
(Perform 4 unplug / plug cycles, followed by un plug)
EIA 364-13
5
O
O
-
-
After test : 5N~20N (with virgin plug)
Initial : 8N ~ 20N
Extraction force
Measure at 12.5mm/minute min.
(Perform 4 unplug / plug cycles, followed by un plug)
EIA 364-09
6
After test : 6N~20N (with virgin plug)
Mated 10,000 times
Mechanically operated : 500cycles/hr
Mating stroke : 2.75mm
Durability
No physical damage.
7
O
-
Insertion, extraction force shall be measured
at a maximum speed of 12.5mm/min
Remarks
Drawn
S.K.JANG
21.11.17
Designed
Checked
H.J.LEE
Approved
H.J.LEE
Release
DEPT
22.12.22
ENG
S.K.JANG
21.11.17
21.11.17
21.11.17
[Note] QT : Qualification test, AT : Assurance test, O : Applicable, - : Not applicable
Drawing No. CL No. Part No.
ELC4-633514
CL 6248-0001-0
CX90M3-24P
PRODUCT SPECIFICATION
1
HIROSE KOERA.CO.,LTD
3