COUNT
COUNT
REV
DESCRIPTION OF REVISIONS
BY
CHKD DATE REV
DESCRIPTION OF REVISIONS
BY
CHKD DATE
Revised
Revised
HJ.KIM
HJ.LEE 18.03.06
Revised
YI.KIM
HJ.LEE 21.12.15
-
-
-
-
6
4
5
YG.KIM HJ.LEE 21.08.23
Universal Serial Bus Type-C Cable and Connector Specification Release 2.1
APPLICABLE STANDARD
Universal Serial Bus Type-C Connectors and Cable Assemblies Compliance Document Revision 2.1b
1.25A Max. for each power pin (A1, A4, A9, A12, B1, B4, B5, B9, B12)
0.25A for the other pins
CURRENT
VOLTAGE
RATING
48V AC/DC
OPERATING CONDITION
STORAGE CONDITION
-40℃ ~ +105℃(INCLUDING TEMP. RISE), 95% RH MAX.(NON-CONDENSING)
-10℃ ~ +60℃(WITH PACKING), 15% ~ 70% RH
Para.
1
Test Description
Test Procedure
Test Requirement
No physical damage
QTAT
O O
EIA 364-18
Visual inspection
Examination of product
Electrical Requirements
EIA 364-23
Measure at 20mV max open circuit at
100mA(DC OR 1000Hz).
Low Level Contact
Resistance
40mΩ max initial for each contact.
50mΩ max after initial measurement.
2
O -
4-wire measurement is required and the
resistance of PCB termination shall be
deducted from the reading.
EIA 364-20
Dielectric
Withstanding Voltage
Measure per Method B with unmated
condition.
100VAC RMS for 1 minute at sea level.
3
No disruptive discharge.
O -
EIA 364-21
500VDC with unmated and mated condition.
4
Insulation Resistance
100MΩ Min.
O -
Mechanical Requirements
EIA 364-13
Measure at 12.5mm/minute min.
Initial & After test : 5N to 20N
(with virgin plug)
5
6
Insertion force
Extraction force
O -
O -
Initial : 8N to 20N
After test : 6N to 20N
(with virgin plug)
EIA 364-13
Measure at 12.5mm/minute min.
EIA 364-09
10,000 insertion/extration cycles.
Cycle rate : 500±50 cycles per hour.
Low level contact resistance and
dielectric withstanding voltage shall
meet the spec after test.
7
Durability
Vibration
O -
EIA 364-28
Test Condition VII, Test Letter D
20-500 Hz random levels, 15minutes in
No physical damage and no
discontinuity longer than 1us.
Low level contact resistance shall
8
O -
each of 3 mutually perpendicular directions. meet spec before and after the test.
REMARKS
DRAFT
DESIGN
CHECK
APPROVAL
RELEASE
DEPT
21.12.15
ENG
H.J.LEE
T.S.KANG
16.08.03
H.J.KIM KN.ICHIKAWA
16.08.03 16.08.03
16.08.03
NOTE) QT : QUALIFICATION TEST, AT : ASSURANCE TEST, O: Applicable Test
DWG NO CL NO
PART NO
CX90B1-24P
ELC4-632149
CL 6240-0004-7
1
HIROSE KOREA.CO.,LTD
PRODUCT SPECIFICATION
3