COUNT
-
COUNT
DESCRIPTION OF REVISIONS
REV
DESCRIPTION OF REVISIONS
BY
CHKD DATE REV
BY
CHKD DATE
Revised
KYI
LHJ
21.12.15
59
Universal Serial Bus Type-C Cable and Connector Specification Release 2.1
APPLICABLE STANDARD
Universal Serial Bus Type-C Connectors and Cable Assemblies Compliance Document Revision 2.1b
1.25A Max. for each power pin (A1, A4, A9, A12, B1, B4, B5, B9, B12)
0.25A for the other pins
CURRENT
VOLTAGE
RATING
48V AC/DC
-40℃ ~ +105℃ (INCLUDING TEMP. RISE), 95% RH max. (NON-CONDENSING)
-10℃ ~ +60℃ (WITH PACKING), 15% ~ 70% RH
OPERATING CONDITION
STORAGE CONDITION
Para.
1
Test Description
Test Procedure
Test Requirement
QTAT
O O
EIA 364-18
Visual inspection
No physical damage.
Examination of product
Electrical Requirements
EIA 364-23
Measure at 20mV max open circuit
at 100mA (DC OR 1000Hz).
4-wire measurement is required and
the resistance of PCB termination
shall be deducted from the reading.
Low Level Contact
Resistance
Initial : 40mΩ max for each contact
2
O -
After test : 50mΩ max for each contact
EIA 364-20
Dielectric
Withstanding Voltage
Measure per Method B with
unmated condition.
No disruptive discharge.
3
O -
100V AC RMS for 1 minute at sea level.
EIA 364-21
4
Insulation Resistance
100MΩ min.
O -
500V DC with unmated and mated condition.
Mechanical Requirements
EIA 364-13
Initial & after test : 5N ~ 20N
(with virgin plug)
5
6
Insertion force
Extraction force
O -
O -
Measure at 12.5mm/minute min.
EIA 364-13
Initial : 8N ~ 20N
Measure at 12.5mm/minute min.
After test : 6N ~ 20N (with virgin plug)
EIA 364-09
Mated 10,000 times
Mechanically operated : 500cycles/hr
Mating stroke : 2.75mm
No physical damage.
No physical damage.
7
Durability
O -
Insertion, extraction force shall be measured
at a maximum speed of 12.5mm/min
EIA 364-28
Test Condition VII, Test Letter D
Mated specimens to 3.10 G's RMS
between 20 to 500Hz
No discontinuity of 1μs of longer
duration when mated connector
during test.
8
Random Vibration
O -
15 minutes in each of 3 mutually
perpendicular planes.
REMARKS
DRAFT
DESIGN
CHECK
APPROVAL
RELEASE
DEPT
21.12.15
ENG
J.H.BOO
17.06.07
H.J.KIM
H.J.LEE
T.S.KANG
17.06.07
17.06.07
17.06.07
NOTE) QT : QUALIFICATION TEST, AT : ASSURANCE TEST, O : Applicable Test
DWG NO CL NO
PART NO
ELC4-632525
CL 6240-0005-0
CX80B1-24P
1
HIROSE KOREA.CO.,LTD
PRODUCT SPECIFICATION
3